Treatment of real carwash wastewater using high-efficiency and energy-saving electrocoagulation technique

This study focused on the treatment of actual wastewater from a car wash facility using electrocoagulation. The primary objective was to decrease chemical oxygen demand (COD) and eliminate turbidity by employing various electrodes such as Stainless Steel (SS) 304, Galvanized Iron (GI), and aluminum foil (alpha-Al) in a batch configuration. Several factors including contact time, current density, initial pH, and electrode material were examined to optimize process efficiency. The sludge generated during electrocoagulation was analyzed using Scanning Electron Microscopy/Energy-Dispersive X-ray Spectrometry (SEM-EDS). The results indicated that COD removal efficiency initially decreased between 30 and 60 min before improving. The data for COD, turbidity, and total phosphate reduction aligned well with the pseudo-first-order kinetic model, with R2 values of 0.275, 0.898, and 0.522, respectively. Minor variations were observed in pH, Total Dissolved Solids (TDS), Electrical Conductivity (EC), and alkalinity, while the temperature increased from 12 to 18.6 degrees C. Optimal removal efficiency for turbidity, total phosphate, and COD was achieved at pH = 6. The study demonstrated that higher current density resulted in enhanced COD reduction and turbidity removal. Chloride levels decreased with increasing applied current. The alpha-Al electrode exhibited superior performance compared to SS 304 and GI electrodes, with notable pH fluctuations during the process. UV-visible absorption spectra indicated differences in treated wastewater patterns based on the electrode utilized. SEM analysis revealed distinct characteristics of sludge produced by different electrodes. Energy and electrode consumption varied among the electrodes, with SS 304 displaying the lowest values.