Effect of anodizing pretreatment on laser joining stainless steel to CFRTP

Metal-carbon fiber reinforced thermoplastic (CFRTP) hybrid joints have demonstrated its effectiveness in achieving lightweight design concept in engineering application. However, it is difficult to produce highreliability joint due to differences in physical as well as chemical properties between metal and CFRTP. In this study, porous oxide film was prepared by anodizing treatments with various anodic oxidation times on steel surface to enhance joint performance of laser-welded steel/CFRTP. The maximum steel/CFRTP joint fracture load of 1960 N was reached, which was three times as much as that obtained with pretreated steel. The results indicated that porous structure was introduced into steel surface by anodization process, which resulted in better wettability of molten CFRTP and higher surface roughness, thus contributing to the enhancement of joint area as well as mechanical interlocking at the interface, further improving joint performance. Meanwhile, more Cr-O-C chemical bonds were produced because Cr-rich oxide film formed after anodizing contributed to interfacial chemical reaction. The chemical bond between oxide film and CFRTP was proved through density functional theory (DFT) calculation. Additionally, with the increase of anodic oxidation time, chemical bond content and surface roughness first enhanced and then reduced, which suggested that the porous structure prepared with 20 min anodizing time could best improve the interfacial mechanical interlocking, and promote the chemical bonding as well as steel/CFRTP joint interfacial bonding.