Comparative investigation of structural, morphological, mechanical, tribological and electrochemical properties of TiO2 films formed on Cp-Ti, Ti6Al4V and Ti45Nb alloys

This study focuses on the comparison of structural, morphological, mechanical, tribological and electrochemical properties of TiO2 films fabricated on Cp-Ti, Ti6Al4V and Ti45Nb alloys, which are widely used in different industries. For this purpose, TiO2 films were grown on Cp-Ti, Ti6Al4V and Ti45Nb materials by anodization method. Structural, morphological and mechanical properties of the samples were determined using XRD, SEM, Micro Raman, contact angle, surface roughness and micro hardness devices. Afterwards, the samples were subjected to wear and corrosion tests using a pin-on-disc wear device and a corrosion device, respectively. Wear tests were carried out in both dry and liquid environments. In electrochemical corrosion tests, Ringer's solution was used and open circuit potential (OCP) and electrochemical polarization analyzes were performed. According to the results of XRD and Raman analyses, it was determined that TiO2 films were successfully grown on the surface of the samples. Additionally, it was observed that these films were in Rutile and Anatase phases and their peak intensities increased with increasing anodization time. While the thickest films were obtained from Ti45Nb samples, the thinnest films were obtained from Cp-Ti samples. As a result of the increase in surface roughness with anodization, surface wettability increased in all samples. It was seen that electrical resistance of the materials was highly effective on the film thickness, surface roughness and surface structures. Wear coefficients decreased in all samples for both dry and liquid wear conditions due to the increased surface hardness and anodic film thickness and the lowest wear coefficients were obtained from the Ti45Nb sample. Corrosion performance of the samples increased with anodization because TiO2 films acted as protective layers on surface of materials.