Influence of nickel contents on synthesis gas production over nickel-based catalysts supported by treated activated carbon in dry reforming of methane

This study focuses on the utilization of activated carbon (AC) as a catalyst support after undergoing treatment with HNO3. The treated AC exhibited a microporous structure and a high specific surface area (SBET) of 1483.8 m2 g-1. In this study, supported nickel-based catalysts were synthesized using the wet impregnation method with varying amounts of NiO (2.5, 5, 7.5, 10, 12.5, and 15 wt%). The calcined catalyst samples were then evaluated for their performance in the dry reforming of methane (DRM). Characterization of the catalysts was conducted through FESEM, TPO, H2-TPR, XRD, and N2 adsorption-desorption (BET) analyses. The results revealed that catalytic efficiency increased with an increase in the nickel loading percentage, up to 12.5 wt%. The NiO (12.5)/ AC catalyst demonstrated the highest CH4 (60%) and CO2 (68%) conversions and exhibited good stability at 700 degrees C during 10 h of reaction. Additionally, the catalyst's efficiency decreased with an increase in the calcination temperature from 400 to 600 degrees C. However, alterations in the CH4/CO2 molar ratio from 0.5 to 1.5 indicated that CH4 and CO2 conversions decreased from 85% to 40% and increased from 63% to 74% at 700 degrees C, respectively. Moreover, the findings demonstrated that elevating the gas hourly space velocity (GHSV) from 12,000 to 18,000 ml h- 1.g- 1 cat resulted in a decline in catalytic efficiency at a temperature of 700 degrees C. Moreover, the catalytic efficiency declined with an increase in the reduction temperature from 500 to 600 degrees C.