Microstructural evolution and mechanical properties of FeCrNiCuTix high entropy alloys

In this study, the microstructural evolution and mechanical properties of a series of FeCrNiCuTix (x = 0, 0.2, 0.4, 0.6, 0.8, and 1, in mole ratio) high entropy alloys (HEAs) were analyzed in detail to study the influence of Ti content on the HEAs. The microstructures of the alloys transformed from single-phase face-centered cubic (FCC) phase structure to FCC and body-centered cubic (BCC) diphase, finally to FCC, BCC and intermetallic compound (Fe2Ti) phase with the increase of Ti content. The addition of Ti element significantly refined the grain of the alloys. The hardness, strength and tribology tests of the alloys were also carried out. The results indicated that the Vickers hardness, yield strength, and fracture strength increased first and then decreased, the average friction coefficient variation law was just the opposite, and the plastic strain reduced monotonically, with the increase of x values for the alloys. At x = 0.4, the maximum yield strength and fracture strength of the alloy were 1646.89 MPa and 1947.09 MPa, respectively, and the average friction coefficient was a minimum of 0.47, with a hardness value of HV 489.68 and a plastic strain of 13.98%. The maximum hardness value of the alloy was HV 656.19 at x = 0.8. The fracture mechanism of the alloys was from ductile fracture to brittle fracture and the wear mechanism was form of abrasive wear. Accordingly, the FeCrNiCuTi0.4 alloy obtained the optimal mechanical properties overall. This research is of great significance for the development of engineering and structural materials with excellent mechanical properties.