Performance analysis and optimization of two-stage heat pipe-cooled thermoelectric chiller

被引：0
|
作者：
Chen Z.-J. [1 ]
Meng F.-K. [1 ]
Xu C.-X. [1 ]
机构：
[1] College of Power Engineering, Naval University of Engineering, Wuhan
来源：
Gongcheng Kexue Xuebao/Chinese Journal of Engineering | 2022年 / 44卷 / 12期
关键词：
coefficient of performance; cooling load; distribution ratio of thermoelectric elements; extreme cooling temperature difference; finite-time thermodynamics; heat pipe; two-stage thermoelectric chiller;
D O I：
10.13374/j.issn2095-9389.2021.05.09.005
中图分类号：
学科分类号：
摘要：
When compared with the traditional refrigeration method that uses a refrigerant as a working medium, thermoelectric refrigeration is a new type of solid-state active environmental protection refrigeration method. This method is based on the Peltier effect of semiconductor thermoelectric materials, which directly converts electrical energy into a temperature gradient. Thermoelectric refrigeration has the advantages of simple structure, compact structure, rapid cooling, and accurate control of refrigeration temperature. When compared with a single-stage thermoelectric cooler, a two-stage thermoelectric cooler can ensure greater cooling temperature difference and efficiency. A heat pipe is a heat transfer component that uses liquid-phase transition to transfer heat. It has good isothermal stability, efficient thermal conductivity, and small size. For good heat dissipation capacity of heat pipes and higher cooling temperature difference in two-stage thermoelectric coolers, a two-stage thermoelectric chiller model based on heat pipe heat dissipation is proposed. Based on finite-time and nonequilibrium thermodynamics, various thermoelectric effects, including the Thomson effect, are considered. The effects of working current, distribution ratio of thermoelectric elements, and heat pipe geometric parameters (heat pipe outer diameter, evaporating section length, and wick thickness) on the device-cooling load, coefficient of performance (COP), and extreme cooling temperature difference are analyzed by the numerical simulation method. Under a certain total logarithm constraint of the thermoelectric unit, the cooling load and the COP are taken as the targets. The working current and distribution ratio of thermoelectric elements are used as the variables to optimize device performance. The influence of key parameters on the optimal variables and optimal performance is analyzed, and the optimal interval of the coordinated cooling load and COP is obtained. By optimizing the distribution ratio and current of thermoelectric elements, the cooling load and COP of the device significantly improved. When ∆T=20 K, x = 0.6, I = 2.5 A, the optimized cooling load and COP reach 23.42 W and 1.53, respectively, which are 12.11% and 218.75% higher than those before optimization. © 2022 Science Press. All rights reserved.
引用
收藏
页码：2177 / 2188
页数：11
相关论文
共 41 条
  • [11] Li C C, Jiang F X, Liu C C, Et al., Present and future thermoelectric materials toward wearable energy harvesting, Appl Mater Today, 15, (2019)
  • [12] Wu L, Gao M, Zhang T, Et al., Thermoelectric cooling application and optimization: A review, J Refrig, 40, 6, (2019)
  • [13] Meng F K, Chen L G, Sun F R., Optimal performance of a thermoelectric generator-driven thermoelectric refrigerator system, J Eng Thermophys, 30, 11, (2009)
  • [14] Meng F K, Chen L G, Ge Y L, Et al., Cooling load optimization of A single-stage multi-element thermoelectric refrigerator, J Eng Thermophys, 33, 12, (2012)
  • [15] Chen L G, Meng F K, Sun F R., Effect of heat transfer on the performance of thermoelectric generator-driven thermoelectric refrigerator system, Cryogenics, 52, 1, (2012)
  • [16] Ruiz Ortega P, Olivares-Robles M., Analysis of a hybrid thermoelectric microcooler: Thomson heat and geometric optimization, Entropy, 19, 7, (2017)
  • [17] Pourkiaei S M, Ahmadi M H, Sadeghzadeh M, Et al., Thermoelectric cooler and thermoelectric generator devices: A review of present and potential applications, modeling and materials, Energy, 186, (2019)
  • [18] Nami H, Nemati A, Yari M, Et al., A comprehensive thermodynamic and exergoeconomic comparison between single- and two-stage thermoelectric cooler and heater, Appl Therm Eng, 124, (2017)
  • [19] Xuan X C, Ng K C, Yap C, Et al., The maximum temperature difference and polar characteristic of two-stage thermoelectric coolers, Cryogenics, 42, 5, (2002)
  • [20] Cheng Y H, Shih C., Maximizing the cooling capacity and COP of two-stage thermoelectric coolers through genetic algorithm, Appl Therm Eng, 26, 8-9, (2006)
12345