Pressureless sintering of B4C whisker reinforced Al2O3 matrix composites

Al2O3-B4C whisker composites have been successfully densified by pressureless sintering. Low oxygen partial pressures, below 10\documentclass[12pt]{minimal} \usepackage{amsmath} \usepackage{wasysym} \usepackage{amsfonts} \usepackage{amssymb} \usepackage{amsbsy} \usepackage{mathrsfs} \usepackage{upgreek} \setlength{\oddsidemargin}{-69pt} \begin{document} $$^{ - 10} $$ \end{document} atmospheres, were determined to be suitable for the composite densification, and the maximum densities were achieved at 1800 °C for 60 minutes. The B4C whiskers were screened classified into five size fractions and the effect of size and size distribution on the densification were studied. The small whiskers with a narrow size distribution (−325 + 400 mesh) yielded the highest density results. The maximum value of relative densities was 98%, 97%, 94% and 89% at 10, 20, 30 and 40 vol  % B4C whiskers, respectively. Addition of B4C between 5 and 15 vol % proved to be a sintering aid to the alumina densification via mechanisms other than being a grain growth inhibitor. An increased fracture toughness up to 6.2 MPa·m\documentclass[12pt]{minimal} \usepackage{amsmath} \usepackage{wasysym} \usepackage{amsfonts} \usepackage{amssymb} \usepackage{amsbsy} \usepackage{mathrsfs} \usepackage{upgreek} \setlength{\oddsidemargin}{-69pt} \begin{document} $$^{{\raise0.7ex\hbox{$1$} \!\mathord{\left/ {\vphantom {1 2}}\right.\kern-\nulldelimiterspace} \!\lower0.7ex\hbox{$2$}}} $$ \end{document} was achieved in the composites containing 10–20 vol % B4C whiskers.