New Method of Eutectic Silicon Modification in Cast Al–Si Alloys

The aim of the present work was to investigate various means of obtaining a fine eutectic silicon structure in A356.2 alloy and therefore improve the alloy mechanical properties. The effects of solidification rate, Sr modification and melt thermal treatment (MTT) on the silicon particle characteristics of A356.2 (Al–7 %Si–0.4 %Mg) alloy were studied. The particle characteristics measured were the average particle area, average particle length, average particle roundness and average particle aspect ratio, using image analysis and optical microscopy. The results showed that Sr modification-, superheat- and Sr modification-MTT (SrMTT)-processed castings provide fine eutectic Si particles, the SrMTT process giving the best modification results. Both size and morphology of the eutectic silicon particles are affected by the modification process used. The Sr-grain-refined, Sr-melt superheat and SrMTT castings show well-modified fibrous Si particles, whereas the MTT casting exhibits Si particles that, although refined to a certain extent, still retain their acicular morphology. Solidification rate affects the eutectic Si particle size in that a higher solidification rate produces finer Si particles. However, within the range of solidification rates provided by the end-chill mold used in this work, the solidification rate does not affect the morphology of the Si particles.