Phosphorus sorption-desorption characteristics of ditch sediments from different land uses in a small headwater catchment in the central Sichuan Basin of China

Investigation of phosphorus (P) sorption-desorption characteristics of drainage ditch sediments is important for better understanding on sediment P transport behaviors in ditches. Surface ditch sediment samples were collected from headwater subcatchment of forestland, sloping cropland, paddy field, and residential area in a representative catchment in the central Sichuan Basin. These sediment samples were used for determination of P sorption-desorption characteristics by a batch equilibrium technique. Results showed that the maximum P sorption capacities (Qm) in the sediments ranged from 159.7 to 263.7 mg/kg, while higher Qm were observed in the ditch sediments from the paddy fields. The Qm was significantly and positively correlated with oxalate-extractable Fe and Al oxides (r=0.97 and 0.98, p < 0.01), clay fraction (r = 0.78, p < 0.05) and organic matter (r = 0.95, p < 0.01). Sediment pH, clay and organic matter influenced the P sorption through amorphous Fe and Al oxides. CaCO3 content was negatively correlated with the Qm (r = −0.83, p < 0.05), implying that saturated CaCO3 (> 50 g/kg) would not increase P sorption capacity in the ditch sediments. The ditch sediments featured a linear desorption curve, suggesting that P release risk would be enhanced with the increase of the P adsorption. The P desorption rate was positively correlated with Olsen P (r = 0.94, p < 0.01), but negatively related to the fine particle-size fractions (r = −0.92, p < 0.01), the sum of the amorphous Fe and Al oxides (r = −0.67, p < 0.05) and the P sorption capacity (r = −0.59, p < 0.05). The ditch sediments from residential area had a higher P release risk than that from the other ditches of forestland, sloping cropland and paddy field. The P sorption index (PSI) derived from single-point measurement was significantly correlated with the P sorption capacity (r = 0.99, p < 0.01), and could be used for estimating Qm as 1.64 times PSI plus 24.0 (Qm = 1.64 PSI + 24.0) for similar sediments with highly calcareous soils and sediments. Ditch cleaning and sediment removal for the ditch in residential area were recommended in this area to reduce the P release risk.