Influence of Friction Stir Processing on Weld Temperature Distribution and Mechanical Properties of TIG-Welded Joint of AA6061 and AA7075

The joining of dissimilar materials is required in many engineering and defense applications, and the conventional fusion welding often results in defective welds. The friction stir welding has minimized the welding defects, but not completed. This work focuses on the effect of friction stir processing on TIG-welded joints with filler ER 5356 to improve the mechanical properties of TIG-welded joints. In this paper, the FSP tool pin rotates on an already welded joint by TIG welding to lower the welding load and improve the weld quality by adjusting the processing parameters of friction stir processing. After analyzing the mechanical properties of TIG + FSP-welded joint, computational fluid dynamics-based numerical model was developed to predict the temperature distribution and material flow during TIG + FSP of dissimilar aluminum alloys AA6061 and AA7075 by ANSYS fluent software. The minimum compressive residual stress 18 MPa, maximum tensile strength (281.1 MPa) and hardness (107 HV) were located at the nugget zone of the TIG + FSP weldment at tool rotation speed of 1300 rpm, traverse speed of 30 mm/min and tilt angle 2°. The predicted peak values of temperature at the weld region were calculated and the maximum temperature (505 °C) and maximum heat flux (2.93 × 106 w/m2) were observed at a tool rotation of 1300 rpm.