Non-linear stress and failure analyses of adhesively-bonded joints subjected to a bending moment

In this paper, the mechanical behavior of the Single-Lap Joints (SLJs) bonded with two different adhesives (FM 73 and SBT 9244) under a bending moment was analyzed, both experimentally and numerically. Four-point bending experiments for the joints With different overlap lengths were carried Out and fracture Surfaces of the SLJs were examined with a Scanning Electron Microscope (SEM). After the stress analysis in the SLJs was performed via a finite element method by considering the material non-linearities of the adhesives and adherend (AA2024-T3), the Finite Element Analysis (FEA) results were compared with experimental results. Finally, the stress analyses and experimental results show that the failure in the SLJs subjected to a bending moment probably initiates from the overlap region on the adhesive-upper adherend interface in tension and propagates towards the centre of the overlap. Also, in the joint subjected to a bending moment, it is seen that the load carried by the SLJ with SBT 9244 adhesive with increasing overlap length is more than that of the SLJ with FM 73 adhesive, although in the bulk form FM 73 adhesive is about three times stronger than SBT 9244 adhesive.