A worn tool force model for three-dimensional cutting operations

Previous studies have shown that there is a region on the flank of a worn cutting tool where plastic flow of the workpiece material occurs. This paper presents experimental data which shows that in three-dimensional cutting operations in which the nose of the tool is engaged, the region of plastic flow grows linearly with increases in total wearland width. A piecewise linear model is developed for modeling the growth of the plastic flow region, and the model is shown to be independent of cutting conditions. A worn tool force model for three-dimensional cutting operations that uses this concept is presented. The model requires a minimal number of sharp tool tests and only one worn tool test. An integral part of the worn tool force model is a contact model that is used to obtain the magnitude of the stresses on the flank of the tool. The force model is validated through comparison to data obtained from wear tests conducted over a range of cutting conditions and workpiece materials. It is also shown that for a given tool and workpiece material combination, the incremental increases in the cutting forces due to tool flank wear are solely a function of the amount and nature of the wear and are independent of the cutting condition in which the tool wear was produced. (C) 2000 Elsevier Science Ltd. All rights reserved.