Effect of Li content on ageing precipitation behavior of Al-Mg-Si alloy

被引：2
|
作者：
Yang Xiao-kun [1 ,2 ,3 ]
Xiong Bai-qing [1 ,3 ]
Li Xi-wu [1 ,2 ,3 ]
Yan Li-zhen [1 ,2 ,3 ]
Li Zhi-hui [1 ,3 ]
Zhang Yong-an [1 ,2 ,3 ]
Li Ya-nan [1 ,2 ,3 ]
Wen Kai [1 ,2 ,3 ]
机构：
[1] GRINM Grp Corp Ltd, State Key Lab Nonferrous Met & Proc, Beijing 100088, Peoples R China
[2] GRIMAT Engn Inst Co Ltd, Beijing 101407, Peoples R China
[3] Gen Res Inst Nonferrous Met, Beijing 100088, Peoples R China
来源：
CAILIAO GONGCHENG-JOURNAL OF MATERIALS ENGINEERING | 2021年 / 49卷 / 06期
关键词：
Al-Li alloy; Al-Mg-Si alloy; precipitation phase; precipitate-free zone; microstructure; MECHANICAL-PROPERTIES; MICROSTRUCTURE;
D O I：
10.11868/j.issn.1001-4381.2020.000794
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
The effect of Li content on the ageing precipitation behavior of Al-3.0Mg-0.6Si alloy was investigated by transmission electron microscopy. The evolution and distribution of the precipitation phases in alloys with different Li contents during the artificial ageing at 170 degrees C were analyzed. The results show that the addition of Li changes the ageing precipitation behavior of Al-3.0Mg-0.6Si alloy. In the alloy with 2.15% (mass fraction) Li addition, the spherical delta'-Al-3 Li phases are formed first in grain interiors, while the needle-shaped beta ''-Mg2Si phases gradually precipitate at the later ageing stage. After ageing for 192 h, there are obviously dual phase precipitation of spherical delta' phase and needle-shaped beta '' phase formed. However, beta '' phase precipitation is not found in the alloy with 3.12% Li addition during the observed ageing stage. In addition, there are no precipitation phases at the grain boundaries of the Li-containing alloys, and the precipitate-free zones (delta'-PFZs) and delta' phase are found nearby the grain boundaries. After ageing for 100 h, the alloy with 2.15% Li addition precipitates needle-shaped beta '' phase in the delta'-PFZs regions. Both the half width size and growth rate of the delta-PFZs in the alloy with 2.15%Li addition are greater than that of 2.68%,3.12% Li alloys.
引用
收藏
页码：100 / 108
页数：9
相关论文
共 20 条
  • [1] Strengthening mechanisms, deformation behavior, and anisotropic mechanical properties of Al-Li alloys: A review
    Abd El-Aty, Ali
    Xu, Yong
    Guo, Xunzhong
    Zhang, Shi-Hong
    Ma, Yan
    Chen, Dayong
    [J]. JOURNAL OF ADVANCED RESEARCH, 2018, 10 : 49 - 67
  • [2] Influence of plastic deformation on the precipitation sequence in an AA6061 alloy
    Chbihi, A.
    Vincent, S.
    Ribis, J.
    Toffolon-Masclet, C.
    Garnier, J.
    [J]. JOURNAL OF MATERIALS SCIENCE, 2017, 52 (10) : 6063 - 6073
  • [3] Thermodynamic calculated and TEM observed microstructure of Al-Li-Mg-Si alloys
    Chen, R
    Huang, Z
    Chen, CQ
    Shen, JY
    Zhang, YG
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2000, 280 (01): : 146 - 150
  • [4] The synergistic effect of Li addition on microstructure, texture and mechanical properties of extruded Al-Mg-Si alloys
    Din, Shamas Ud
    Kamran, J.
    Tariq, N. H.
    Hasan, B. A.
    Petrov, R. H.
    Bliznuk, V.
    Zuha, Shamas Uz
    [J]. MATERIALS CHEMISTRY AND PHYSICS, 2016, 174 : 11 - 22
  • [5] Effect of Li addition on microstructure and mechanical properties of Al-Mg-Si alloy
    Din, Shamas Ud
    Bin Awais, Hasan
    Tariq, Naeem ul Haq
    Mehmood, Mazhar
    [J]. INTERNATIONAL JOURNAL OF MATERIALS RESEARCH, 2014, 105 (08) : 770 - 777
  • [6] The structural and compositional evolution of precipitates in Al-Mg-Si-Cu alloy
    Ding, Lipeng
    Jia, Zhihong
    Nie, Jian-Feng
    Weng, Yaoyao
    Cao, Lingfei
    Chen, Houwen
    Wu, Xiaozhi
    Liu, Qing
    [J]. ACTA MATERIALIA, 2018, 145 : 437 - 450
  • [7] Full-potential KKR calculations for point defect energies in Al
    Hoshino, T
    Nakamura, F
    [J]. METASTABLE, MECHANICALLY ALLOYED AND NANOCRYSTALLINE MATERIALS, 2005, 24-25 : 237 - 240
  • [8] HUANG ZW, 1991, MATER SCI TECH SER, V7, P205, DOI 10.1179/026708391790183385
  • [9] HUANG ZW, 1994, MATER SCI TECH SER, V10, P869, DOI 10.1179/026708394790163285
  • [10] GRAIN-BOUNDARY PRECIPITATE FREE ZONES IN AL-LI ALLOYS
    JHA, SC
    SANDERS, TH
    DAYANANDA, MA
    [J]. ACTA METALLURGICA, 1987, 35 (02): : 473 - 482
12