An experimental investigation of a passive cooling unit for nuclear plant containment

A set of condensation experiments in the presence of noncondensables (e.g. air, helium) was conducted to evaluate the heat removal capacity of a passive cooling unit in a post-accident containment. Condensation heat transfer coefficients on a vertically mounted smooth tube have been obtained for total pressure ranging from 2.48 x 10(5) Pa(abs) to 4.55 x 10(5) Pa(abs) and air mass fraction ranging from 0.30 to 0.65. An empirical correlation for heat transfer coefficient (h), has been developed in terms of a parameter group made up of steam mole fraction (Xs), total pressure (P-t), temperature difference between bulk gas and wall surface (dT). This correlation covers all data points within 20%. All data points are also in good agreement with the prediction of the diffusion layer model (DLM) with suction and are approximately 2.2 times the Uchida heat transfer correlation. Experiments with an axial shroud around the test tube to model the restriction on radial flow experienced within a tube bundle demonstrated a reduction of the heat transfer coefficient by a factor of about 0.6. The effect of helium (simulating hydrogen) on the heat transfer coefficient was investigated for helium mole fraction in noncondensable gases (X-He/X-nc) at 15, 30 and 60%. It was found that the condensation heat transfer coefficients are generally lower when introducing helium into noncondensable gas. The difference is within 20% of air-only cases when X-He/X-ac is less than 30% and total pressure is less than 4.55 x 105 Pa(abs). A gas stratification phenomenon was clearly observed for helium mole fraction in excess of 60%. (C) 2000 Elsevier Science S.A. All rights reserved.