A pedal dynamometer for off-road bicycling

This paper describes the design and accuracy evaluation of a dynamometric pedal, which measures the two pedal force components in the plane of the bicycle. To realize a design that could be used during actual off-road cycling, a popular clipless pedal available commercially was modified so that both the form and the function of the original design were maintained To measure the toad components of interest, the pedal spindle was replaced with a spindle fixed to the pedal body and instrumented with eight strain gages connected into two Wheatstone bridge circuits. The new spindle is supported by bearings in the crank arm. Static calibration and a subsequent accuracy check revealed root mean square errors of less than 1 percent full scale (FS) when only the force components of interest were applied. Application of unmeasured load components created an error less than 2 percent FS. The natural frequency with half the weight of a 75 kgf person standing on the pedal was greater than 135 Hz. These performance capabilities make the dynamometer suitable for measuring either pedaling loads due to the rider's muscular action or inertial loads due to surface-induced acceleration. To demonstrate this suitability, sample pedal load data are presented both for steady-state ergometer cycling and coasting over a rough surface while standing.