Effect of ambient relative humidity and surface modification on the charge decay properties of polymer powders in powder coating

Back corona on a powder layer deposited via the electrostatic powder-coating process using corona guns has a strong influence on the corrosion resistance and appearance of cured powder films. The presence of the back corona is often evidenced by orange peel, micro-dents, and pinholes on the film surface. The surface resistivity of the sprayed powder governs the charge decay process and, hence, the onset of back corona. The polymer powders used in powder coating are highly resistive, with surface resistivity often greater than 10(15) Omega/rectangle. Surface resistivity can be altered by the adsorption of moisture on the surfaces of the powder particles. The objectives of this research were: 1) investigate the effect of decreasing surface resistivity on the appearance of the powder-coated film and 2) enhance hydrophilic properties of polymer powder by plasma treatment. By changing the relative humidity (RH) of powder during the spraying process, it was observed that the surface resistivity could be lowered by orders of magnitude. For example, the surface resistivity for an acrylic powder decreased from 2.96 x 10(13) Omega/rectangle at 25% RH to 9.6 x 10(11) Omega/rectangle at 70% RH. The plasma treatment of this powder further improved its charge decay properties. The effects of variation of RH on the appearance of powder-coated panels surface layer are presented for an acrylic polymer powder. The film texture has been characterized by microstructural surface analysis using an optical scanning instrument. Methods of plasma and corona treatments of the powder for increasing moisture adsorption on the surface and decreasing surface resistivity are discussed along with analysis of surface morphology using the atomic force microscope.