A self-powered discrete time piezoelectric vibration damper

被引:14
|
作者
Konak, MJ [1 ]
Powlesland, IG [1 ]
van der Velden, SP [1 ]
Galea, SC [1 ]
机构
[1] DSTO, Airframes & Engines Div, Aeronaut & Maritime Res Lab, Melbourne, Vic 3001, Australia
关键词
vibration suppression; damping; STAMP; vibration damper; passive damping; active vibration control;
D O I
10.1117/12.293506
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Structural vibration suppression is of great interest to the aircraft industry as it can reduce the amplitude of excessive vibration in lightly damped panels caused by conditions In their operational environment. One technique of suppressing vibration is to use passive damping techniques such as constrained layered damping incorporating viscoelastic materials. However these techniques may not be acceptable because of weight concerns or extreme temperature variations, Over the past decade much work has been done by researchers on ?he use of piezoelectric ceramic devices, using passive and active techniques, for structural vibration suppression. The passive piezoelectric damping devices consist of a piezoelectric element and either a resistive or resonant shunt. The resonant circuit shunt, which is analogous to a mechanical vibration absorber, gives better vibration reduction compared to the resistor shunt, This device requires a large value of inductance in order to be tuned to a particular structural vibration mode, A large value inductor can be made by using a gyrator type circuit however the circuit needs external power. A method of vibration control using a discrete time controller and piezoelectric devices is presented. That is, this paper describes the concept of a self-powered discrete time piezoelectric vibration damper which does not need tuning to the structural resonant frequency and is powered by piezoelectric elements, i.e. does not need ail external power supply. This device is referred To as a Strain Amplitude Minimisation Patch (STAMP) damper. A brief description of the theory used and of the scheme is presented. Also the operation of this device is compared with other 'passive' techniques, involving piezoelectric elements, such as the resistive passive damper and the parallel resonant passive damper cases. Experimental results presented, on a cantilevered beam, demonstrate the concept and show that the device, even in its current underdeveloped form, has better damping than the simple resistor damper. Measurements taken indicate that the maximum RMS tip accelerations, at resonance, are reduced by 17.3%, 62.7% and 39.5% for the resistor, parallel resonant and STAMP damper devices, respectively, when compared to the short circuit reference condition. The performance of each device is observed when the resonant frequency of the system changes when a mass is added to the lip of the cantilever. This paper also discusses areas where improvements in the performance of the STAMP damper can be achieved.
引用
收藏
页码:270 / 279
页数:10
相关论文
共 50 条
  • [1] Analysis of a self-powered piezoelectric vibration damper
    Konak, MJ
    Powlesland, IG
    van der Velden, SP
    Galea, SC
    [J]. SMART STRUCTURES AND DEVICES, 2001, 4235 : 328 - 339
  • [2] A New Self-Powered Electromagnetic Damper for Structural Vibration Control
    Jamshidi, Maziar
    Chang, Chih Chen
    [J]. SENSORS AND SMART STRUCTURES TECHNOLOGIES FOR CIVIL, MECHANICAL, AND AEROSPACE SYSTEMS 2017, 2017, 10168
  • [3] Self-powered hybrid electromagnetic damper for cable vibration mitigation
    Jamshidi, Maziar
    Chang, C. C.
    Bakhshi, Ali
    [J]. SMART STRUCTURES AND SYSTEMS, 2017, 20 (03) : 285 - 301
  • [4] Development of a Self-Powered Magnetorheological Damper System for Cable Vibration Control
    Wang, Zhihao
    Chen, Zhengqing
    Gao, Hui
    Wang, Hao
    [J]. APPLIED SCIENCES-BASEL, 2018, 8 (01):
  • [5] On Piezoelectric Vibration Generator for Self-Powered Wireless Sensor Network
    He, Qing
    Yan, Zhen
    Wang, Xueyang
    [J]. SENSOR LETTERS, 2011, 9 (05) : 1869 - 1873
  • [6] Self-powered circuit for broadband, multimodal piezoelectric vibration control
    Lallart, Mickael
    Lefeuvre, Elie
    Richard, Claude
    Guyomar, Daniel
    [J]. SENSORS AND ACTUATORS A-PHYSICAL, 2008, 143 (02) : 377 - 382
  • [7] The Design and Application of Piezoelectric Friction Damper with Self-Powered and Sensing Control System
    Dai, NaXin
    Tan, Ping
    Zhou, FuLin
    [J]. ADVANCES IN STRUCTURES, PTS 1-5, 2011, 163-167 : 2477 - 2481
  • [8] Feasibility Study of a Self-powered Magnetorheological Damper for Vibration Control of a Stay Cable
    Wang, Zhihao
    Chen, Zhengqing
    [J]. ADVANCES IN ENVIRONMENTAL VIBRATION, 2011, : 875 - 882
  • [9] Highly Reliable Real-time Self-powered Vibration Sensor Based on a Piezoelectric Nanogenerator
    Zhu, Jie
    Niu, Xushi
    Hou, Xiaojuan
    He, Jian
    Chou, Xiujian
    Xue, Chenyang
    Zhang, Wendong
    [J]. ENERGY TECHNOLOGY, 2018, 6 (04) : 781 - 789
  • [10] Experimental study on a self-powered piezoelectric sensor under vibration environment
    Yuan, Jiangbo
    Xie, Tao
    Shan, Xiaobiao
    Chen, Weishan
    [J]. ISAF: 2009 18TH IEEE INTERNATIONAL SYMPOSIUM ON THE APPLICATIONS OF FERROELECTRICS, 2009, : 346 - 349