A novel technique for optimising the harmonics and reactive power under non-sinusoidal voltage conditions

The conventional power factor correction techniques assume the voltage source to be purely sinusoidal. But this is rarely true because the non-sinusoidal currents drawn by non-linear loads incur non-sinusoidal voltage drops across source impedance and transmission line impedance. The result is a non-sinusoidal voltage supply applied to the load. Under such conditions, any attempt to make the power factor unity by usual methods will result into a non-sinusoidal current, which increases total harmonic distortion (THD). On the other hand attempt for harmonic free current may not result in unity power factor because of harmonies present in the voltage. Thus, there is a trade off between improvement in power factor and reduction of THD. With the law enforcing agencies getting more vigilant about power quality, it has become unavoidable to optimise power factor while satisfying harmonies limits. In this paper, a novel technique for optimisation of harmonics and power factor subject to power quality constraints is presented for non-sinusoidal voltage conditions. The technique is based on Lagrange multiplier method and calculates the concerned control coefficients by Newton Raphson method. This is used to compute the desired source current for optimum power factor satisfying the power demand of the load while meeting the THD limits. Knowing the load current, the compensating current that must be supplied by the active filter to the power system can be calculated. The proposed scheme does not use the widely used p-q theory and is applicable for both the single-phase and three-phase systems. Analysis using MATLAB has shown encouraging results. The scheme is being implemented in hardware using DSP.