Experimental investigation on the heat transfer of an impinging inverse diffusion flame

This paper presents the results of an experimental study on the heat transfer characteristics of an inverse diffusion flame (IDF) impinging vertically upwards on a horizontal copper plate. The IDF burner used in the experiment has a central air jet surrounded circumferentially by 12 outer fuel jets. The heat flux at the stagnation point and the radial distribution of heat flux were measured with a heat flux sensor. The effects of Reynolds number, overall equivalence ratio, and nozzle-to-plate distance on the heat flux were investigated. The area-averaged heat flux and the heat transfer efficiency were calculated from the radial heat flux within a radial distance of 50 mm. from the stagnation point of the flame, for air jet Reynolds number (Re-air) of 2000, 2500 and 3000, for overall equivalence ratios (Phi) of 0.8-1.8, at normalized nozzle-to-plate distances (H/d(IDF)) between 4 and 10. Similar experiments were carried out on a circular premixed impinging flame for comparison. It was found that, for the impinging IDF, for Phi of 1.2 or higher, the area-averaged heat flux increased as the Re-air or Phi was increased while the heat transfer efficiency decreased when these two parameters increased. Thus for the IDF, the maximum heat transfer efficiency occurred at Re-air = 2000 and Phi = 1.2. At lower Phi 0, the heat transfer efficiency could increase when Phi was decreased. For the range of HI d(IDF) investigated, there was certain variation in the heat transfer efficiency with H/d(IDF). The heat transfer efficiency of the premixed flame has a peak value at Phi = 1.0 at H/d(P) = 2 and decreases at higher Phi and higher H/d(P). The IDF could have comparable or even higher heat transfer efficiency than a premixed flame. (c) 2007 Elsevier Ltd. All rights reserved.