CRACKING OF FERRITIC STAINLESS STEEL TUBES DURING PRODUCTION PROCESS

From the economic reasons many products originally made from austenite stainless steel are nowadays made from ferritic stainless steel. Ferritic steels have relatively low yield strength and the work hardening is limited. They cannot be hardened by heat treatment and only moderately hardened by cold working. Commercially made stainless steel tubes from ferritic steel, used for industrial plumbing was examined on presence of cracks. The cracking was present on the inner side of the convoluted tube shape. The tube manufacturing process consisted of continual bending of the sheet to tube shape, weld the tube, then of cold shaping by pulling through rib-forming frames, which is done in several steps. Then thermal treatment applies to the nearly finished product to remove stress remaining in the structure. Prime suspect was deformation beyond the ductility of used material. However the stress-strain tensile testing does not approved this hypothesis. Several samples of failed material were taken together with reference, and were examined by optical microscopy, and X-Ray Diffraction structure analysis. The structure of the cracked tubes does not show the signs of deformation over the limit, except the location near to the crack itself. Interestingly enough the failed material showed more homogenous structure than the original one. Needle like structures were found when the material is "overetched", on these structures concentration of stress under bending occur. This structure was identified as sic-ferrite however its presence in alpha-ferrite matrix is unclear.