Unified correlation of in-plane and out-of-plane creep constraints with creep crack growth rate

In this paper, the equivalent creep strain distributions ahead of crack tips in SEN(B), SEN(T) and M(T) specimens with different in-plane and out-of-plane constraints were calculated by extensive finite element analyses, and the creep crack growth (CCG) rates of these specimens were simulated over a wide range of C-star by using stress dependent creep ductility and strain rate model in a ductility exhaustion based damage model. The capability and applicability of the constraint parameter A, based on crack-tip equivalent creep strain for characterizing both in-plane and out-of-plane creep crack-tip constraints and establishing a unified correlation with CCG rate of a steel were investigated. The results show that with increasing constraints, the CCG rate increases, and the effect of out-of-plane constraint on CCG rate is more obvious than that of in-plane constraint. The CCG rate of high constraint specimen geometry (such as SEN(B)) is more sensitive to the out-of-plane and in-plane constraints than that of low constraint specimen geometry (such as M(T)). The parameter A(c) is a unified characterization parameter of in-plane and out-of-plane creep constraints for the different specimen geometries. Base on the parameter Ac, the unified correlation formulas of in-plane and out-of-plane constraints with CCG rate of the steel have been obtained, and they are independent on the choices of the standard specimen. The unified correlation formulas may be used in constraint-dependent CCG life assessments of high-temperature components (such as pressure vessels and pipes) with any in-plane and out-of-plane constraint levels. (C) 2016 Elsevier Ltd. All rights reserved.