Shear creep deformation of the super alloy single crystal CMSX-4 at high temperatures and low stresses

In the present paper we investigate the shear creep behavior of the single crystal super alloy CMSX-4 at temperatures between 950 and 1100degreesC and shear stresses ranging from 80 to 155 MPa. A double shear creep test technique is used to study the shear creep behavior of four specific macroscopic crystallographic shear systems defined by a specific crystallographic shear plane and a specific crystallographic shear direction (systems investigated: {001}<110>, {100}<010>, {011}<01-1>, and {111}<01-1>). The shear creep behavior is analyzed in terms of the shape of individual creep curves and in terms of the stress and the temperature dependence of the secondary shear creep rate. Individual creep curves are generally characterized by a pronounced primary creep range where creep rates decrease by up to three orders of magnitude. A sharp creep rate minimum is not observed. The secondary creep range starts at shear stresses of the order of 0.02 and is followed by a secondary creep range which extends over shear strain ranges of the order of 0.1. No pronounced increase of shear creep rate in the later stages of creep is observed. Norton plots yield power law stress exponents ranging from 5.5 to 9.7. The temperature dependence of the secondary creep rate is of an Arrhenius type and apparent activation energies between 549 and 690 kJ/mol were found. There is a clear influence of crystallography on shear creep rates, which vary between different macroscopic crystallographic shear systems; this effect decreases with increasing temperature. The shear creep results obtained in the present study are discussed in the light of results from uniaxial testing and in the light of underlying microscopic deformation processes.