Zinc sulfate addition to glass-ionomer-based cements: influence on physical and antibacterial properties, zinc and fluoride release

Objectives: The aim of this study is to evaluate the effect of ZnSO4 addition to a conventional glass ionomer and a resin-modified glass ionomer on solubility, flexural strength, zinc and fluoride (F) release, and Streptococcus mutans growth inhibition. Methods: 5 or 10% ZnSO4 was added to Vitremer and Ketac-Fil powders. Solubility test was performed based on ISO 7489. Flexural strength was determined by 3-point bending test based on ISO 4049. Zn release/uptake was determined by atomic emission spectrometry; F release/uptake was measured using a F-specific electrode. Both release measurements were performed for 15 d before and 15 d after recharging. Antibacterial test was conducted according to agar plate methods against S. mutans, by measuring the inhibition halos in 1-h and 15-d specimens. Data were analyzed by ANOVA. Results: Solubility increased with higher ZnSO4 content, but remained below the ISO 7489 limit. Flexural strength was not affected by ZnSO4 addition, and Vitremer performed better than Ketac-Fil. The control materials released no zinc. Vitremer with 10% ZnSO4 released the highest amount of zinc. Fluoride release was similar for Ketac-Fil and Vitremer. In both cases, the highest amounts were released in the first 24 h. The growth inhibition halo of S. mutans was similar for both materials with highest content of ZnSO4 and occurred only with 1-h specimens. Significance: Zinc addition decreased microorganisms growth and improved fluoride release, without significantly affecting the materials' flexural strength and solubility. (C) 2003 Published by Elsevier Science Ltd on behalf of Academy of Dental Materials.