Investigation of the temperature-dependent electrical properties of Au/PEDOT:WO3/p-Si hybrid device

被引:8
|
作者
Keskin, Mine [1 ]
Akkaya, Abdullah [2 ]
Ayyildiz, Enise [3 ]
Oksuz, Aysegul Uygun [4 ]
Karakus, Mucella Ozbay [5 ]
机构
[1] Erciyes Univ, Grad Sch Nat & Appl Sci, Dept Phys, TR-38039 Kayseri, Turkey
[2] Ahi Evran Univ, Mucur Tech Vocat Sch, Tech Prog Dept, TR-40500 Kirsehir, Turkey
[3] Erciyes Univ, Dept Phys, Fac Sci, TR-38039 Kayseri, Turkey
[4] Suleyman Demirel Univ, Fac Arts & Sci, Dept Chem, TR-32260 Isparta, Turkey
[5] Bozok Univ, Dept Comp Engn, Fac Engn & Architecture, TR-66000 Yozgat, Turkey
关键词
CURRENT-VOLTAGE CHARACTERISTICS; SCHOTTKY DIODE; THIN-FILMS; HETEROJUNCTION; TRANSPORT; CONTACT; LIQUID; SENSOR; LAYER;
D O I
10.1007/s10854-019-02048-8
中图分类号
TM [电工技术]; TN [电子技术、通信技术];
学科分类号
0808 ; 0809 ;
摘要
The electrical properties of Au/PEDOT:WO3/p-Si hybrid devices were studied in terms of current-voltage (I-V) and capacitance-voltage (C-V) measurements. Poly (3,4-ethylene dioxythiophene/tungsten trioxide (PEDOT:WO3) composite was prepared by an in situ chemical oxidative polymerization of monomer in 1-butyl-3-methylimidazoliumtetrafluoroborate (BMIMBF4). Optical and structural properties of the PEDOT:WO3 thin film was characterized by using FTIR, UV-Vis and AFM techniques. The bandgap energy of PEDOT:WO3 thin film was determined as 2.07 eV from UV-Vis spectrum. It was seen that the I-V plots of the Au/PEDOT:WO3/p-Si hybrid devices were non-linear and C-2-V plots were linear in the reverse bias defining rectification behavior. The values of barrier height obtained from the I-V and C-2-V plots of the fabricated devices were found to be 0.729 +/- 0.012 eV and 0.817 +/- 0.011 eV at room temperature in the dark environment, respectively. Devices have a high rectification behavior with a rectification ratio of 3.645 x 10(5) at +/- 1 V. The temperature-dependent I-V characteristics of one of the devices were also analyzed on the basis of the thermionic emission theory at low forward bias voltage regime. It was observed that the values of ideality factor decrease while the values of barrier height increase with increasing temperature. This kind of temperature dependence was attributed to the presence of the barrier inhomogeneity at the hybrid film/inorganic semiconductor interface. Then, by analysing of the forward bias I-V characteristics at double logarithmic scale, it was seen that the carrier transport in the Au/PEDOT:WO3/p-Si hybrid device demonstrates the space-charge-limited current (SCLC) conduction mechanism controlled by a trap distribution above the valence band edge dominates in the range 0.1-0.3 V voltages. Furthermore, by analyzing the reverse bias I-V-T characteristics, it was shown that Schottky emission was the dominating current conduction mechanism in the temperature range of 240-320 K.
引用
收藏
页码:16676 / 16686
页数:11
相关论文
共 50 条
  • [1] Investigation of the temperature-dependent electrical properties of Au/PEDOT:WO3/p-Si hybrid device
    Mine Keskin
    Abdullah Akkaya
    Enise Ayyıldız
    Ayşegül Uygun Öksüz
    Mücella Özbay Karakuş
    Journal of Materials Science: Materials in Electronics, 2019, 30 : 16676 - 16686
  • [2] Temperature-dependent electrical characteristics of Alq3/p-Si heterojunction
    Karabulut, Abdulkerim
    Orak, Ikram
    Canli, Serdal
    Yildirim, Nezir
    Turut, Abdulmecit
    PHYSICA B-CONDENSED MATTER, 2018, 550 : 68 - 74
  • [3] Temperature-Dependent Electrical Transport and Optoelectronic Properties of SnS2/p-Si Heterojunction
    Singh, Deependra Kumar
    Pant, Rohit
    Roul, Basanta
    Chowdhury, Arun Malla
    Nanda, Karuna Kar
    Krupanidhi, Saluru Baba
    ACS APPLIED ELECTRONIC MATERIALS, 2020, 2 (07) : 2155 - 2163
  • [4] Effect of annealing temperature on nanostructured WO3 films on P-Si substrate
    Hossain, M. F.
    Takahashi, T.
    5TH BSME INTERNATIONAL CONFERENCE ON THERMAL ENGINEERING, 2013, 56 : 702 - 706
  • [5] Investigation of microstructural, optical and dc electrical properties of spin coated Al:WO3 thin films for n-Al:WO3/p-Si heterojunction diodes
    Raja, M.
    Chandrasekaran, J.
    Balaji, M.
    Kathirvel, P.
    OPTIK, 2017, 145 : 169 - 180
  • [6] Electrical investigation of Al/PEDOT/C/p-Si structure
    Kaya, Fikriye Seyma
    Ozer, Tuba Oznuluer
    Turgut, Guven
    Yurtcan, Ayse Bayrakceken
    Duman, Songul
    RESULTS IN PHYSICS, 2019, 13
  • [7] Investigating the optoelectronic device performance of p-Si/WO3/Ag sandwich structure
    Aljawrneh, Bashar
    Ocak, Yusuf Selim
    Albiss, Borhan Aldeen
    Celik, Omer
    Alshanableh, Abdelelah
    JOURNAL OF SANDWICH STRUCTURES & MATERIALS, 2025,
  • [8] Effect of Pt layers on the photoelectrochemical properties of a WO3/p-Si electrode
    Yoon, KH
    Seo, DK
    Cho, YS
    Kang, DH
    JOURNAL OF APPLIED PHYSICS, 1998, 84 (07) : 3954 - 3959
  • [9] Photoelectrochemical conversion in a WO3 coated p-Si photoelectrode: Effect of annealing temperature
    Yoon, KH
    Shin, CW
    Kang, DH
    JOURNAL OF APPLIED PHYSICS, 1997, 81 (10) : 7024 - 7029
  • [10] Electrical conduction and photodiode properties of Au/Feq3/p-Si/al hybrid heterostructure
    El-Menyawy, E. M.
    El-Khalawany, L. M.
    Zedan, I. T.
    PHYSICA B-CONDENSED MATTER, 2024, 685