A comprehensive evaluation of planetary boundary layer height retrieval techniques using lidar data under different pollution scenarios

被引:10
|
作者
Wang, Futing [1 ,2 ]
Yang, Ting [1 ,3 ]
Wang, Zifa [1 ,2 ,3 ]
Chen, Xi [1 ,2 ]
Wang, Haibo [1 ,2 ]
Guo, Jianping [4 ]
机构
[1] Chinese Acad Sci, Inst Atmospher Phys, State Key Lab Atmospher Boundary Layer Phys & Atm, Beijing 100029, Peoples R China
[2] Univ Chinese Acad Sci, Beijing, Peoples R China
[3] Chinese Acad Sci, Inst Urban Environm, Ctr Excellence Reg Atmospher Environm, Xiamen 361021, Peoples R China
[4] Chinese Acad Meteorol Sci, State Key Lab Severe Weather, Beijing 100081, Peoples R China
基金
国家高技术研究发展计划(863计划);
关键词
Planetary Boundary layer height; Lidar algorithms; Comparison; Diurnal evolution;
D O I
10.1016/j.atmosres.2021.105483
中图分类号
P4 [大气科学(气象学)];
学科分类号
0706 ; 070601 ;
摘要
Lidar is a powerful active remote sensing technique to monitor the planetary boundary layer (PBL), and there have already been many algorithms to retrieve the planetary boundary layer height (PBLH) using aerosol lidars. However, the algorithm suitable for all atmospheric conditions doesn't exist. This study evaluates the capability of nine lidar algorithms under different pollution scenarios in terms of the instantaneous performance and the diurnal evolution, which are derived from classical theories and expressed as GM, LGM, CRGM, IPM, VAR, VGM, WCT, WCTD, and POLARIS in this paper. Based on the nine algorithms, the continuous PBLHs are obtained from the observation dataset of a Beijing urban site in 2017. In order to verify the lidar results, the statical comparison analysis with radiosonde is also presented. On the premise of the inversion hypothesis, such as sufficient mixing in the PBL, the consistency of lidar results was the best, with the difference being not more than 200 m. And what's different from our cognition is that the concentration of pollutants near the ground under the light pollution condition makes the lidar results tend to be consistent. In fact, LGM prefers to get higher PBLHs because of filtering the information near the ground, whereas POLARIS is apt to underestimate unless the actual morphology can be captured by the depolarization ratio. VAR and IPM are more vulnerable to the conspicuous stratification. GM, CRGM, and WCTD have better consistency with radiosonde and capture the evolution characteristic no matter in clean or polluted days. Compared with the clean days, PBLH from lidar algorithms under the polluted condition reduced about 500 m overall, as well as the standard deviation. Generally speaking, the comprehensive comparison provides a reference to choose the proper lidar algorithm when retrieving the PBLH. GM is appropriate for the detection of clean days, while CRGM is robust for polluted days. WCTD is more suitable for the judgment of PBLH in the morning and evening and will underestimate at noon. As to the situation with cloud, WCTD is also the best choice.
引用
收藏
页数:11
相关论文
共 49 条
  • [1] A comprehensive evaluation of planetary boundary layer height retrieval techniques using lidar data under different pollution scenarios
    Wang, Futing
    Yang, Ting
    Wang, Zifa
    Chen, Xi
    Wang, Haibo
    Guo, Jianping
    Atmospheric Research, 2021, 253
  • [2] Optimization Method for Planetary Boundary Layer Height Retrieval by Lidar
    Yu S.
    Liu D.
    Xu J.
    Wang Z.
    Wu D.
    Qian L.
    Mao M.
    Wang Y.
    Guangxue Xuebao/Acta Optica Sinica, 2021, 41 (07):
  • [3] Optimization Method for Planetary Boundary Layer Height Retrieval by Lidar
    Yu Siqi
    Liu Dong
    Xu Jiwei
    Wang Zhenzhu
    Wu Decheng
    Qian Liyong
    Mao Minjuan
    Wang Yingjian
    ACTA OPTICA SINICA, 2021, 41 (07)
  • [4] Evaluation of retrieval methods for planetary boundary layer height based on radiosonde data
    Li, Hui
    Liu, Boming
    Ma, Xin
    Jin, Shikuan
    Ma, Yingying
    Zhao, Yuefeng
    Gong, Wei
    ATMOSPHERIC MEASUREMENT TECHNIQUES, 2021, 14 (09) : 5977 - 5986
  • [5] Evaluation of retrieval methods of daytime convective boundary layer height based on lidar data
    Li, Hong
    Yang, Yi
    Hu, Xiao-Ming
    Huang, Zhongwei
    Wang, Guoyin
    Zhang, Beidou
    Zhang, Tiejun
    JOURNAL OF GEOPHYSICAL RESEARCH-ATMOSPHERES, 2017, 122 (08) : 4578 - 4593
  • [6] Using scanning backscatter lidar to determine planetary boundary layer height
    Huseyinoglu, M.F.
    Lasers in Engineering, 2018, 39 (3-6): : 153 - 161
  • [7] Using Scanning Backscatter Lidar to Determine Planetary Boundary Layer Height
    Huseyinoglu, M. F.
    LASERS IN ENGINEERING, 2018, 39 (3-6) : 153 - 161
  • [8] Statistically Resolved Planetary Boundary Layer Height Diurnal Variability Using Spaceborne Lidar Data
    Roldan-Henao, Natalia
    Yorks, John E.
    Su, Tianning
    Selmer, Patrick A.
    Li, Zhanqing
    REMOTE SENSING, 2024, 16 (17)
  • [9] Lidar algorithms in 3D scanning or atmospheric layering and planetary boundary layer height retrieval: comparison with other techniques
    Pantazis, Alexandros
    Papayannis, Alexandros
    Georgousis, Georgios
    APPLIED OPTICS, 2018, 57 (28) : 8199 - 8211
  • [10] Characterization of the planetary boundary layer height and structure by Raman lidar: comparison of different approaches
    Summa, D.
    Di Girolamo, P.
    Stelitano, D.
    Cacciani, M.
    ATMOSPHERIC MEASUREMENT TECHNIQUES, 2013, 6 (12) : 3515 - 3525