Forward modelling of seismicity rate changes in georeservoirs with a hybrid geomechanical-statistical prototype model

A key challenge for the development of Enhanced Geothermal Systems (EGS) is to forecast the probability of occurrence of seismic events that have the potential to damage man-made structures. Induced seismicity results from man-made time-dependent stress changes, e.g., due to fluid injection, shut-in and fluid or steam production. To accomplish a classical Probabilistic Seismic Hazard Assessment (PSHA) a catalogue of induced seismicity is required. In addition, PSHA does not return any practical recommendation for how to treat the reservoir geomechanically in order to lower the probability of occurrence of induced seismicity. Thus, we propose to link the simulated stress changes from forward geomechanical numerical reservoir models with the statistical rate-and-state approach of Dieterich (1994). Using this link we translate the modelled time-dependent stress changes into time-dependent changes of seismicity rates. This approach is general and independent of the incorporated geomechanical numerical model used. We exemplify our hybrid model approach using a geomechanical model that describes the stimulation of the well GPK4 at the EGS site in Soultz-sous-Forets (France) including the shut-in phase. By changing the injection rate in the geomechanical model we generate various synthetic injection scenarios. With these scenarios we can study the effect on the seismicity rate and provide a recommendation for which injection experiment results in the least increase of seismicity rate. The results indicate an explicit coupling between the time-depending stress changes and the induced seismicity rate for each scenario. Even though the hybrid model cannot be used in general to derive absolute values of the rate of induced seismicity a priori (this is only possible if the geomechanical model can be calibrated against observed induced events), it serves as a tool to test the effect of stress changes on the induced seismicity rate. The approach described here is a prototype model illustrating the general workflow. In particular the geomechanical model can be replaced by any other type of reservoir description. (C) 2014 Elsevier Ltd. All rights reserved.