A description of phase inversion behaviour in agitated liquid-liquid dispersions under the influence of the Marangoni effect

The influence of the Marangoni effect on phase inversion behaviour is examined by integrating a microscopic study of the drop coalescence process, in which thin film drainage in the presence of insoluble surfactant occurs, into a macroscopic phase inversion model which has been developed previously using a Monte Carlo technique. This is achieved via an immobility factor, obtained from a comparison of the film drainage times for surfactant-laden systems and surfactant-free systems as a function of the drop approach velocity, surface Peclet number, initial surfactant concentration and the Hamaker constant, which is then used to modify the coalescence probability in the phase inversion model. On the one hand, the results indicate that the Marangoni effect removes any influence that the viscosity ratio has on phase inversion due to immobilisation of the interface, thus shielding the flow in the film from the effects of the flow in the dispersed phase; the point at which phase inversion occurs therefore tends towards equivolume holdups with the addition of surfactant. On the other hand, when comparisons are made with pure systems in which surfactant is absent, the system is seen to be either stabilised or de-stabilised from inversion depending on the viscosity ratio of the system. This is attributed to the influence of surfactant on the dispersion morphologies on either side of the inversion (i.e. water-in-oil dispersions and oil-in-water dispersions) and depends on the dispersed phase holdup; the Marangoni effect is felt stronger when the dispersed phase holdup is low. (C) 2002 Elsevier Science Ltd. All rights reserved.