A numerical investigation of boundary layer suction in compound lean compressor cascades

This paper is focused on the numerical investigation of boundary layer suction (BLS) via a slot on the suction surfaces of two compound lean compressor cascades with large camber angles as well as a conventional straight compressor cascade for comparison. The objective of the investigation is to study the influence of boundary layer suction on the performance of compound lean compressor cascades, thus to discuss the possibility of the application of boundary layer suction to improve their performance. An extensive numerical study has been carried out under different spanwise lengths and different axial positions of the slots, and different suction flow rates. The results show that the total loss of all three cascades is reduced significantly by boundary layer suction, and the largest reduction occurs at the highest suction flow rate. The axial locations of the slot have little effect on the total loss of the three cascades, which means the slots are opened within the optimal axial range in this case. The slot opened along the full span is the best one to obtain the largest reduction in total loss for all three cascades due to the alleviation of flow separation in the corner between the endwall and the suction surface. Moreover, the flow turning is increased, and pressure rise at the rear of the passage is recovered along the whole blade height via boundary layer suction along the full span, enhancing the working range of the highly loaded compressor cascades.