Ni-SDC cermet anode fabricated from NiO-SDC composite powder for intermediate temperature SOFC

被引：45

作者：

Misono, Teruhiko

Murata, Kenji

Fukui, Takehisa

Chaichanawong, Jintawat

Sato, Kazuyoshi

Abe, Hiroya

Naito, Makio

机构：

[1] Hosokawa Powder Technol Res Inst, Osaka 5731132, Japan

[2] Osaka Univ, Joining & Welding Res Inst, Osaka 5670047, Japan

来源：

JOURNAL OF POWER SOURCES | 2006年 / 157卷 / 02期

关键词：

Ni-SDC; ceramic powder processing; composite powder; microstructural control;

D O I：

10.1016/j.jpowsour.2006.01.074

中图分类号：

O64 [物理化学（理论化学）、化学物理学];

学科分类号：

070304 ; 081704 ;

摘要：

We report a cost-effective processing method for fabricating intermediate temperature solid oxide fuel cells (SOFCs) with Ni-samaria doped ceria (SDC) anode. First, SDC and NiO powders were mechanically treated to make their composite powder. Then, the composite powder was applied into a ceramic tape casting method to form a thick layer for the anode supporting. Finally, an anode supported single cell with a configuration of Ni-SDC/SDC/La0.6Sr0.4CO0.2Fe0.8O3-delta (LSCF) was prepared. Because of the usage of the composite powder, homogenous distribution and connection of each Ni and SDC were achieved. Peak power densities of 460, 750 and 910mW cm(-2) were obtained on the single cell at 550, 600 and 650 degrees C, respectively. (c) 2006 Elsevier B.V. All rights reserved.

引用

页码：754 / 757

页数：4

共 50 条

[1] Fabrication and Characterization of SOFC Anode, Ni-SDC Cermet
Li Yan1
2. Department of Physics
[J]. Journal of Rare Earths, 2006, (01) : 38 - 38
[2] Reaction Process in the Ni-SDC Cermet Anode
Kishimoto, Haruo
Yamaji, Katsuhiko
Horita, Teruhisa
Xiong, Yue-Ping
Brito, Manuel E.
Yoshinaga, M.
Yokokawa, Harumi
[J]. ELECTROCHEMISTRY, 2009, 77 (02) : 190 - 194
[3] The effect of calcination temperature on the properties of Ni-SDC cermet anode
Ahsan, Muhammad
Irshad, Muneeb
Fu, Pei Fang
Siraj, Khurram
Raza, Rizwan
Javed, Fayyaz
[J]. CERAMICS INTERNATIONAL, 2020, 46 (03) : 2780 - 2785
[4] Microstructural Characteristics of SDC Electrolyte Film Supported by Ni-SDC Cermet Anode
Ou, Ding Rong
Mori, Toshiyuki
Ye, Fei
Miyayama, Masaru
Nakayama, Satoshi
Zou, Jin
Auchterlonie, Graeme J.
Drennan, John
[J]. JOURNAL OF THE ELECTROCHEMICAL SOCIETY, 2009, 156 (07) : B825 - B830
[5] Development of La-Doped Ni-SDC Anode for High Performance IT-SOFC of Ni-SDC/LSGM/SSC
Kawahara, K.
Suda, S.
Kawano, M.
Yoshida, H.
Inagaki, T.
[J]. SOLID OXIDE FUEL CELLS 11 (SOFC-XI), 2009, 25 (02): : 2061 - 2066
[6] Synthesis and performances of Ni-SDC cermets for IT-SOFC anode
Chen, Min
Kim, Bok Hee
Xu, Qing
Nam, O. Jeong
Ko, Jung Hoon
[J]. JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2008, 28 (15) : 2947 - 2953
[7] Synthesis of matrix-type NiO-SDC composite particles by spray pyrolysis with acid addition for development of SOFC cermet anode
Kawano, Mitsunobu
Yoshida, Hiroyuki
Hashino, Koji
Ijichi, Hiroshi
Suda, Seiichi
Kawahara, Koichi
Inagaki, Toru
[J]. JOURNAL OF POWER SOURCES, 2007, 173 (01) : 45 - 52
[8] Effect of compaction pressure on the performance of a non-symmetrical NiO-SDC/SDC composite anode fabricated by conventional furnace
Seyednezhed, Mohadeseh
Rajabi, Armin
Muchtar, Andanastui
Somalu, Mahendra Rao
Ooshaksaraei, Poorya
[J]. JOURNAL OF ASIAN CERAMIC SOCIETIES, 2017, 5 (02): : 77 - 81
[9] Direct Internal Steam Reforming at SOFC with Anode Prepared Using NiO-SDC Composite Particles
Kawano, M.
Matsui, T.
Kikuchi, R.
Yoshida, H.
Inagaki, T.
Eguchi, K.
[J]. SOLID OXIDE FUEL CELLS 10 (SOFC-X), PTS 1 AND 2, 2007, 7 (01): : 1455 - +
[10] Porous NiO-SDC Carbonates Composite Anode for LT-SOFC Applications Produced by Pressureless Sintering
Raharjo, Jarot
Muchtar, Andanastuti
Daud, Wan Ramli Wan
Muhamad, Norhamidi
Majlan, Edy Herianto
[J]. ADVANCES IN MECHANICAL ENGINEERING, PTS 1-3, 2011, 52-54 : 488 - 493

← 1 2 3 4 5 →