Forced convective heat transfer of nanofluids in microchannels

被引:292
|
作者
Jung, Jung-Yeul [1 ]
Oh, Hoo-Suk [1 ]
Kwak, Ho-Young [1 ]
机构
[1] Chung Ang Univ, Dept Mech Engn, Seoul 156756, South Korea
关键词
Convective heat transfer; Friction factor; Microchannel; Nanofluids; EFFECTIVE THERMAL-CONDUCTIVITY; FLOW; FLUIDS; MODEL;
D O I
10.1016/j.ijheatmasstransfer.2008.03.033
中图分类号
O414.1 [热力学];
学科分类号
摘要
Convective heat transfer coefficient and friction factor of nanofluids in rectangular microchannels were measured. An integrated microsystem consisting of a single microchannel on one side, and two localized heaters and five polysilicon temperature sensors along the channel on the other side were fabricated. Aluminum dioxide (Al2O3) with diameter of 170 nm nanofluids with various particle volume fractions were used in experiments to investigate the effect of the volume fraction of the nanoparticles to the convective heat transfer and fluid flow in microchannels. The convective heat transfer coefficient of the Al2O3 nanofluid in laminar flow regime was measured to be increased up to 32% compared to the distilled water at a volume fraction of 1.8 volume percent without major friction loss. The Nusselt number measured increases with increasing the Reynolds number in laminar flow regime. The measured Nusselt number which turned out to be less than 0.5 was successfully correlated with Reynolds number and Prandtl number based on the thermal conductivity of nanofluids. (c) 2008 Elsevier Ltd. All rights reserved.
引用
收藏
页码:466 / 472
页数:7
相关论文
共 50 条
  • [1] Forced convective heat transfer of nanofluids
    Ding, Yulong
    Chen, Haisheng
    He, Yurong
    Lapkin, Alexei
    Yeganeh, Mahboubeh
    Siller, Lidija
    Butenko, Yuriy V.
    [J]. ADVANCED POWDER TECHNOLOGY, 2007, 18 (06) : 813 - 824
  • [2] Multiplicity and stability of forced convective heat transfer in microchannels
    Wang, LQ
    Yang, TL
    [J]. FIRST INTERNATIONAL CONFERENCE ON MICROCHANNELS AND MINICHANNELS, 2003, : 281 - 289
  • [3] Thermal transfer impedance variations by forced convective heat transfer in microchannels
    Ender, Ferenc
    Szekely, Vladimir
    [J]. 2012 SYMPOSIUM ON DESIGN, TEST, INTEGRATION AND PACKAGING OF MEMS/MOEMS (DTIP), 2012, : 119 - 124
  • [4] Forced convective heat transfer in parallel flow multilayer microchannels
    Saidi, M. H.
    Khiabani, Reza H.
    [J]. JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME, 2007, 129 (09): : 1230 - 1236
  • [5] Numerical simulation of convective heat transfer behavior of nanofluids in elliptical microchannels
    Fan, Fengxin
    Fan, Xuyang
    Ma, Danzhu
    Jian, Weiwei
    Li, Zhuang
    [J]. NUMERICAL HEAT TRANSFER PART A-APPLICATIONS, 2024,
  • [6] Forced Convective Heat Transfer of Nanofluids - A Review of the Recent Literature
    Dalkilic, A. S.
    Kayaci, N.
    Celen, A.
    Tabatabaei, M.
    Yildiz, O.
    Daungthongsuk, W.
    Wongwises, S.
    [J]. CURRENT NANOSCIENCE, 2012, 8 (06) : 949 - 969
  • [7] Multiplicity of forced convective heat transfer of nanofluids in curved ducts
    Liu, Fang
    Zhang, Dongxiang
    Cai, Yang
    Qiu, Zhongzhu
    Zhu, Qunzhi
    Zhao, Jun
    Wang, Liqiu
    Tian, Haidong
    [J]. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2019, 129 : 534 - 546
  • [8] Experimental study of forced convective heat transfer of nanofluids in a microchannel
    Anoop, Kanjirakat
    Sadr, Reza
    Yu, Jiwon
    Kang, Seokwon
    Jeon, Saeil
    Banerjee, Debjyoti
    [J]. INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2012, 39 (09) : 1325 - 1330
  • [9] Evaluation of forced convective boiling heat transfer with layered parallel microchannels
    Nishimura, Yusuke
    Okajima, Junnosuke
    Oouchi, Takuya
    Komiya, Atsuki
    [J]. JOURNAL OF THERMAL SCIENCE AND TECHNOLOGY, 2020, 15 (01)
  • [10] INVESTIGATION OF CONVECTIVE HEAT TRANSFER OF AQUEOUS NANOFLUIDS IN MICROCHANNELS INTEGRATED WITH TEMPERATURE NANOSENSORS
    Yu, Jiwon
    Kang, Seok-won
    Jeon, Saeil
    Banerjee, Debjyoti
    [J]. PROCEEDINGS OF THE ASME INTERNATIONAL MECHANICAL ENGINEERING CONGRESS AND EXPOSITION, 2011, VOL 6, PTS A AND B, 2012, : 551 - 556