Effects of injector valve movement on diesel spray characteristics under short full valve opening

被引:1
|
作者
Kawaharada, Noritsune [1 ]
Sakaguchi, Daisaku [1 ]
Ueki, Hironobu [1 ]
Ishida, Masahiro [1 ]
机构
[1] Nagasaki Univ, Grad Sch Engn, Nagasaki 8528521, Japan
来源
关键词
Laser-aided diagnostics; Atomization; Nozzle; Liquid droplet; Fuel injection; Diesel engine; NEEDLE LIFT; FLOW; COMBUSTION; NOZZLES; ENGINE;
D O I
10.1299/jtst.2015jtst0025
中图分类号
O414.1 [热力学];
学科分类号
摘要
A laser 2-focus velocimeter (L2F) was used for the measurement of diesel fuel sprays. Temporal and spatial changes in the number, velocity and size of droplets inside sprays were investigated near the nozzle orifice and were correlated with the needle valve lift of the injector nozzle. The L2F had a micro-scale probe which consists of two foci. The focal diameter was about 3 mu m, and the distance between two foci was 17 mu m. The data sampling rate of the L2F system was markedly high as 15MHz. Fuel sprays were injected intermittently into the atmosphere by using a common rail injector. The orifice diameter of the injector nozzle was 0.112mm and the rail pressure was 40MPa. The periods of solenoid energizing was set at 2.0ms. Measurement positions were located at 10mm downstream from the exit of the nozzle orifice. The results show that droplets mainly existed in the region off the spray center in the early injection period and concentrated at the spray center in the middle of injection period. Temporal changes in the number of droplets near the spray center were strongly affected by the needle lift and there in the relatively wide region were affected by the injection rate. Temporal changes in the droplet velocity near the spray center were strongly affected by the injection rate. The luminance distribution of the spray image was similar to the distribution of the number of droplets multiplied by the square of droplet size.
引用
收藏
页数:12
相关论文
共 50 条
  • [1] EFFECTS OF VALVE STROKES ON SPRAY SHAPES FOR GDI INJECTOR
    Ishii, Eiji
    Yoshimura, Kazuki
    Hosaka, Tomoyuki
    PROCEEDINGS OF THE ASME INTERNAL COMBUSTION ENGINE FALL TECHNICAL CONFERENCE, 2019, 2020,
  • [2] CHARACTERISTICS OF THE SPRAY FROM A DIESEL INJECTOR
    HARDALUPAS, Y
    TAYLOR, AMKP
    WHITELAW, JH
    INTERNATIONAL JOURNAL OF MULTIPHASE FLOW, 1992, 18 (02) : 159 - 179
  • [3] Effect of Upstream Valve Opening Process on Dynamic Spray Atomization of Bipropellant Thruster Injector
    Zhang, Zhen
    Yu, Yusong
    Cao, Jie
    MICROMACHINES, 2022, 13 (04)
  • [4] Effects of Valve, Armature, and Armature Pin Guidance on Diesel Injector Performance
    Isikli, Firat
    Senturk, Gokhan
    Surmen, Ali
    APPLIED SCIENCES-BASEL, 2024, 14 (13):
  • [5] Numerical Study on Cavitation Flow Characteristics in Diesel Fuel Injector Control Valve
    Liu, Jingbin
    Liu, Zhenming
    Wu, Jiechang
    Gu, Xiaolei
    INTERNATIONAL JOURNAL OF AUTOMOTIVE TECHNOLOGY, 2022, 23 (04) : 881 - 897
  • [6] Numerical Study on Cavitation Flow Characteristics in Diesel Fuel Injector Control Valve
    Jingbin Liu
    Zhenming Liu
    Jiechang Wu
    Xiaolei Gu
    International Journal of Automotive Technology, 2022, 23 : 881 - 897
  • [7] Hydrodynamic luminescence in a model diesel injector return valve
    Lockett, Russell D.
    Bonifacio, Alberto
    INTERNATIONAL JOURNAL OF ENGINE RESEARCH, 2021, 22 (03) : 963 - 974
  • [8] Fast opening gas valve for the TCABR pellet injector
    Vannucci, A
    Teixeira, CMD
    Teixeira, FS
    Vuolo, JH
    de Paulo, AC
    Horita, F
    Degasperi, FT
    Elizondo, JI
    Sanada, EK
    Almeida, VAL
    Pantano, F
    BRAZILIAN JOURNAL OF PHYSICS, 2004, 34 (4B) : 1752 - 1755
  • [9] EFFECTS OF OPENING AND CLOSING FUEL-INJECTOR VALVE ON AIR/FUEL MIXTURE
    Ishii, Eiji
    Yoshimura, Kazuki
    Yasukawa, Yoshihito
    Ehara, Hideharu
    PROCEEDINGS OF THE ASME INTERNAL COMBUSTION ENGINE FALL TECHNICAL CONFERENCE, 2016, 2016,
  • [10] Effects of Opening and Closing Fuel-Injector Valve on Air/Fuel Mixture
    Ishii, Eiji
    Yoshimura, Kazuki
    Yasukawa, Yoshihito
    Ehara, Hideharu
    JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2017, 139 (09):