Efficient Reduced Order Modeling of Large Data Sets Obtained from CFD Simulations

被引:2
|
作者
Holemans, Thomas [1 ]
Yang, Zhu [1 ]
Vanierschot, Maarten [1 ]
机构
[1] Katholieke Univ Leuven, Dept Mech Engn, Grp T Leuven Campus, B-3001 Heverlee, Belgium
关键词
computational fluid dynamics; annular swirling jets; large eddy simulation; reduced order modeling; large data sets; spectral proper orthogonal decomposition; DECOMPOSITION;
D O I
10.3390/fluids7030110
中图分类号
O3 [力学];
学科分类号
08 ; 0801 ;
摘要
The ever-increasing computational power has shifted direct numerical simulations towards higher Reynolds numbers and large eddy simulations towards industrially-relevant flow scales. However, this increase in both temporal and spatial resolution has severely increased the computational cost of model order reduction techniques. Reducing the full data set to a smaller subset in order to perform reduced-order modeling (ROM) may be an interesting method to keep the computational effort reasonable. Moreover, non-tomographic particle image velocimetry measurements obtain a 2D data set of a 3D flow field and an interesting research question would be to quantify the difference between this 2D ROM compared to the 3D ROM of the full flow field. To provide an answer to both issues, the aim of this study was to test a new method for obtaining POD basis functions from a small subset of data initially and using them afterwards in the ROM of either the complete data set or the reduced data set. Hence, no new method of ROM is presented, but we demonstrate a procedure to significantly reduce the computational effort required for the ROM of very large data sets and a quantification of the error introduced by reducing the size of those data sets. The method applies eigenvalue decomposition on a small subset of data extracted from a full 3D simulation and the obtained temporal coefficients are projected back on the 3D velocity fields to obtain the 3D spatial modes. To test the method, an annular jet was chosen as a flow topology due to its simple geometry and the rich dynamical content of its flow field. First, a smaller data set is extracted from the 2D cross-sectional planes and ROM is performed on that data set. Secondly, the full 3D spatial structures are reconstructed by projecting the temporal coefficients back on the 3D velocity fields and the 2D spatial structures by projecting the temporal coefficients back on the 2D velocity fields. It is shown that two perpendicular lateral planes are sufficient to capture the relevant large-scale structures. As such, the total processing time can be reduced by a factor of 136 and up to 22 times less RAM is needed to complete the ROM processing.
引用
下载
收藏
页数:13
相关论文
共 50 条
  • [1] Efficient aerodynamic shape optimization through reduced order CFD modeling
    Peng Shengfang
    Zhang Junjie
    Zhang Chunyu
    Optimization and Engineering, 2020, 21 : 1599 - 1611
  • [2] Efficient aerodynamic shape optimization through reduced order CFD modeling
    Peng Shengfang
    Zhang Junjie
    Zhang Chunyu
    OPTIMIZATION AND ENGINEERING, 2020, 21 (04) : 1599 - 1611
  • [3] CFD simulations and reduced order modeling of a refrigerator compartment including radiation effects
    Bayer, Ozgur
    Oskay, Ruknettin
    Paksoy, Akin
    Aradag, Selin
    ENERGY CONVERSION AND MANAGEMENT, 2013, 69 : 68 - 76
  • [4] Efficient nonparametric population modeling for large data sets
    De Nicolao, Giuseppe
    Pillonetto, Gianluigi
    Chierici, Marco
    Cobelli, Claudio
    2007 AMERICAN CONTROL CONFERENCE, VOLS 1-13, 2007, : 1648 - +
  • [5] REDUCED ORDER MODELING OF NEURONS FOR NETWORK SIMULATIONS
    Franklin, C. C.
    Chen, Y.
    Guntu, V. S. K.
    Nair, S. S.
    PROCEEDINGS OF THE ASME 5TH ANNUAL DYNAMIC SYSTEMS AND CONTROL DIVISION CONFERENCE AND JSME 11TH MOTION AND VIBRATION CONFERENCE, DSCC 2012, VOL 1, 2013, : 597 - +
  • [6] Reduced order modeling of neurons for network simulations
    Franklin, C.C.
    Chen, Y.
    Guntu, V.S.K.
    Nair, S.S.
    ASME 2012 5th Annual Dynamic Systems and Control Conference Joint with the JSME 2012 11th Motion and Vibration Conference, DSCC 2012-MOVIC 2012, 2012, 1 : 597 - 603
  • [7] Achieving high efficiency in reduced order modeling for large scale polycrystal plasticity simulations
    Nasirov, Aslan
    Zhang, Xiaoyu
    Wagner, David
    Yeratapally, Saikumar R.
    Oskay, Caglar
    FINITE ELEMENTS IN ANALYSIS AND DESIGN, 2024, 228
  • [8] Sparse and efficient reduced order modeling of linear subcircuits with large number of terminals
    Feldmann, P
    Liu, F
    ICCAD-2004: INTERNATIONAL CONFERENCE ON COMPUTER AIDED DESIGN, IEEE/ACM DIGEST OF TECHNICAL PAPERS, 2004, : 88 - 92
  • [9] Efficient clustering of large data sets
    Ananthanarayana, VS
    Murty, MN
    Subramanian, DK
    PATTERN RECOGNITION, 2001, 34 (12) : 2561 - 2563
  • [10] Efficient algorithms for mining outliers from large data sets
    Ramaswamy, S
    Rastogi, R
    Shim, K
    SIGMOD RECORD, 2000, 29 (02) : 427 - 438