Factors Associated With Clinical Responses to Spinal Manipulation in Patients With Non-specific Thoracic Back Pain: A Prospective Cohort Study

Introduction: The management of musculoskeletal disorders is complex and requires a multidisciplinary approach. Manual therapies, such as spinal manipulative therapy (SMT), are often recommended as an adjunct treatment and appear to have demonstrable effects on pain and short-term disability in several spinal conditions. However, no definitive mechanism that can explain these effects has been identified. Identifying relevant prognostic factors is therefore recommended for people with back pain.Objective: The main purpose of this study was to identify short-term candidate prognostic factors for clinically significant responses in pain, disability and global perceived change (GPC) following a spinal manipulation treatment in patients with non-specific thoracic back pain.Methods: Patients seeking care for thoracic spine pain were invited to participate in the study. Pain levels were recorded at baseline, post-intervention, and 1 week after a single session of SMT. Disability levels were collected at baseline and at 1-week follow-up. GPC was collected post-intervention and at 1-week follow-up. Biomechanical parameters of SMT, expectations for improvement in pain and disability, kinesiophobia, anxiety levels as well as perceived comfort of spinal manipulative therapy were assessed.Analysis: Differences in baseline characteristics were compared between patients categorized as responders or non-responders based on their pain level, disability level, and GPC at each measurement time point. Binary logistic regression was calculated if the statistical significance level of group comparisons (responder vs. non-responders) was equal to, or Results: 107 patients (62 females and 45 males) were recruited. Mean peak force averaged 450.8 N with a mean thrust duration of 134.9 ms. Post-intervention, comfort was associated with pain responder status (p < 0.05) and GPC responder status (p < 0.05), while expectation of disability improvement was associated with GPC responder status (p < 0.05). At follow-up, comfort and expectation of pain improvement were associated with responder GPC status (p < 0.05). No association was found between responder pain, disability or GPC status and biomechanical parameters of SMT at any time point.Discussion: No specific dosage of SMT was associated with short-term clinical responses to treatment. However, expectations of improvement and patient comfort during SMT were associated with a positive response to treatment.