Combustion and soot processes of diesel and rapeseed methyl ester in an optical diesel engine

In-cylinder combustion and soot processes for ultra-low sulphur diesel (ULSD) and rapeseed methyl ester (RME) fuels were investigated in an optically accessible high speed direct injection diesel engine (HSDI) using in situ optical and laser measurement techniques. High speed imaging techniques were used to study the spatial distribution of spray flames, soot formation and oxidation through simultaneous measurements of OH* chemiluminescence and natural soot luminosity, during the luminous combustion process. The amount of un-oxidised soot left in the cylinder after the end of luminous combustion for these fuels were investigated using planar laser induced incandescence (PLII). In addition to PLII, time resolved laser induced incandescence (TR-LII) technique was used simultaneously to explore crank angle resolved variation of primary soot particle size during the expansion stroke. The ignition for RME occurs earlier compared to ULSD, and the early phase of RME combustion proceeds quicker compared to ULSD. The flame lift off length (FLoL) and the length based on the first appearance of soot (SLoL) are longer for RME. The combined effect of relatively longer FLoL and the presence of fuel-bound oxygen reduced the overall soot formation process for RME. PLII data confirmed that the relative amount of soot left in the cylinder after the end of visible luminous combustion is less for RME, and the soot formed are oxidised well within the combustion chamber before it is exhausted out of the engine compared to ULSD. The measured in-cylinder primary soot particles are in the size range between 15 and 35 nm and it decreases with crank angle. The sizes of particles generated from the combustion of RME were slightly smaller compared to ULSD. (C) 2013 Elsevier Ltd. All rights reserved.