Oxygen-enriched combustion of the first cycle during cold start in a liquefied petroleum gas spark-ignition engine

被引:8
|
作者
Li, Gong [1 ]
Li, Liguang
Qiao, Xinqi
Xiao, Guangfei
Qiu, Dongping
机构
[1] Shanghai Jiao Tong Univ, Sch Mech & Power Engn, Inst Internal Combust Engine, Shanghai 200030, Peoples R China
[2] Tongji Univ, Sch Automot Studies, Shanghai 200092, Peoples R China
关键词
liquefied petroleum gas; SI engine; cold-start; first firing cycle; oxygen-enriched combustion;
D O I
10.1243/09544070JAUTO277
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
The first firing cycle is very important for cold-start. Misfire of the first firing cycle can lead to significant hydrocarbon (HQ emissions and affect the subsequent cycles. Research has proved that the oxygen-enriched intake air (OEA) method is a useful technique to reduce cold-phase HC and carbon monoxide (CO) emissions from automotive gasoline engines. However, few researchers have studied oxygen-enriched combustion characteristics based on the first firing cycle analysis during cold-start. The present paper presents a comparison of atmospheric air with OEA in the combustion of the first cycle during cold-start in a liquefied petroleum gas spark-ignition engine. Cylinder pressure, engine speed, HC, CO, and nitric oxide (NO) emissions were collected. The heat release rate of atmospheric air and OEA combustion are calculated. Test results show that atmospheric air and OEA have similar high transients in HC emissions at cold-start. However, OEA reduces CO emissions and increases NO emissions. Comparing the heat release rate curves, oxygen-enriched combustion can lead to heat release earlier and higher than normal air combustion.
引用
收藏
页码:1265 / 1274
页数:10
相关论文
共 50 条
  • [1] Catalyst light-off behavior of a spark-ignition LPG (liquefied petroleum gas) engine during cold start
    Gong, Changming
    Huang, Kuo
    Deng, Baoqing
    Liu, Xunjun
    [J]. ENERGY, 2011, 36 (01) : 53 - 59
  • [2] Performance and Hydrocarbon (HC) Emissions from a Spark-Ignition Liquefied Petroleum Gas (LPG) Engine during Cold Start
    Li, Jun
    Gong, Changming
    Su, Yan
    Dou, Huili
    Liu, Xunjun
    [J]. ENERGY & FUELS, 2009, 23 (09) : 4337 - 4342
  • [3] Effects of Fuel Injection Timing on Combustion and Emissions of a Spark-Ignition Methanol and Methanol/Liquefied Petroleum Gas (LPG) Engine during Cold Start
    Gong, Changming
    Yan, Shufang
    Su, Yan
    Wang, Zhiwei
    [J]. ENERGY & FUELS, 2009, 23 (07) : 3536 - 3542
  • [4] Combustion of a spark-ignition methanol engine during cold start under cycle-by-cycle control
    Gong, Changming
    Deng, Baoqing
    Wang, Shu
    Su, Yan
    Gao, Qing
    Liu, Xunjun
    [J]. ENERGY & FUELS, 2008, 22 (05) : 2981 - 2985
  • [5] Investigation on Firing Behavior of the Spark-Ignition Engine Fueled with Methanol, Liquefied Petroleum Gas (LPG), and Methanol/LPG During Cold Start
    Gong, Changming
    Deng, Baoqing
    Wang, Shu
    Su, Yan
    Gao, Qing
    Liu, Xunjun
    [J]. ENERGY & FUELS, 2008, 22 (06) : 3779 - 3784
  • [6] The operation characteristics of a liquefied petroleum gas (LPG) spark-ignition free piston engine
    Kim, Jaeheun
    Bae, Choongsik
    Kim, Gangchul
    [J]. FUEL, 2016, 183 : 304 - 313
  • [7] The autoignition of Liquefied Petroleum Gas (LPG) in spark-ignition engines
    Morganti, Kai J.
    Brear, Michael J.
    da Silva, Gabriel
    Yang, Yi
    Dryer, Frederick L.
    [J]. PROCEEDINGS OF THE COMBUSTION INSTITUTE, 2015, 35 : 2933 - 2940
  • [8] Effects of ambient temperature on firing behavior and unregulated emissions of spark-ignition methanol and liquefied petroleum gas/methanol engines during cold start
    Gong, Chang-Ming
    Li, Jun
    Li, Jing-Ke
    Li, Wen-Xiang
    Gao, Qing
    Liu, Xun-Jun
    [J]. FUEL, 2011, 90 (01) : 19 - 25
  • [9] MEASUREMENT OF THE COMBUSTION GAS TEMPERATURE IN THE SPARK-IGNITION ENGINE
    SHOJI, H
    [J]. BULLETIN OF THE JSME-JAPAN SOCIETY OF MECHANICAL ENGINEERS, 1985, 28 (245): : 2687 - 2693
  • [10] Spark ignition engine performance analysis of liquefied petroleum gas
    Muhammad, Siti Sabariah binti
    bin Abu Bakar, Rosli
    [J]. 5TH INTERNATIONAL CONFERENCE ON MECHANICAL ENGINEERING RESEARCH 2019 (ICMER 2019), 2020, 788