Microstructure and Texture Evolution of Strip Casting Grain-Oriented Silicon Steel

A 0.23 mm thick grain-oriented silicon steel sheet was successfully produced based on strip casting and two-stage cold rolling route. The evolutions of microstructure and texture along the complete processing route were briefly investigated. It was shown that the as-cast strip was composed of coarse ferrite grains and martensite, and the texture was mainly characterized by strong {001} < 0vw > texture. Goss texture was absent in the hot-rolled strip, which was distinct from the well accepted results that Goss texture had its origin during hot rolling. After the cycle of the first-stage cold rolling, an intermediate annealing, the second-stage cold rolling, and a primary annealing, the strip exhibited a fully recrystallized microstructure with a weak a-fiber texture and a relatively strong gamma-fiber texture. Goss texture was not observed through the thickness of the primary annealed strip. This was significantly different from the previous results that Goss texture was the most populous component in the primary recrystallization texture of two-stage route in conventional process. After secondary recrystalization annealing, the magnetic induction B-8 of the sheet was as high as 1.84 T.