COMBUSTION AND EMISSIONS OF JET-A AND N-BUTANOL IN RCCI OPERATION

Jet-A was investigated in RCCI (Reactivity Controlled Compression Ignition) given that the fuel is readily available and has a similar cetane number compared to ultra-low sulfur diesel (ULSD#2). To promote emissions' control, RCCI was conducted with direct injection (DI) of Jet-A and PFI (port fuel injection) of n-butanol. Combustion and emission characteristics of Jet-A RCCI were investigated for a medium duty DI experimental engine operated at constant boost and 30% EGR rate and compared to ULSD#2 RCCI and single-fuel ULSD#2 operation. DI fuel was injected at 5 CAD ATDC and constant rail pressure of 1500 bar. A 20% pilot by mass was added and investigated at timings from 15 to 5 CAD BTDC for combustion stability. The results showed that the effect of the pilot injection on Jet-A combustion was not as prominent as compared to that of ULSD#2, suggesting a slightly different spray and mixture formation. Ignition delay for Jet-A was 15-20% shorter compared to ULSD#2 in RCCI. When the pilot was set to 5 CAD BTDC, CA50 phased for ULSD#2 RCCI by 3 CAD later when compared to Jet-A RCCI. After TDC, the local pressure maximum for ULSD#2 RCCI decreased by 3 bar, resulting from a 15% difference in peak heat release rate between ULSD#2 and Jet-A in RCCI at the same pilot timing. NOx and soot levels were reduced by a respective maximum of 35% and 80% simultaneously in Jet-A RCCI mode compared to single-fuel ULSD#2, yet, were higher compared to ULSD#2 RCCI. Ringing intensity was maintained at similar levels and energy specific fuel consumption (ESFC) improved by at least 15% for Jet-A compared to ULSD#2 in RCCI. Mechanical efficiencies additionally improved at earlier pilot timing by 2%. In summary, Jet-A RCCI allowed for emissions control and increased fuel efficiencies compared to single fuel ULSD#2, however, injection should be further tweaked in order to reach lower soot levels.