Full-scale testing of laser clad railway track; Case study - Testing for wear, bend fatigue and insulated block joint lipping integrity

This paper reports on a series of tests which were carried out on full-scale sections of rail that had been treated by laser cladding aiming to create a layer (similar to 1-2 mm) of high performance material on the rail head. Experiments were designed to measure wear, lipping of insulated block joints (IBJs) and bending fatigue of clad samples. The wear rate of the clad samples was between 78-89% lower than that of the standard R260 reference sample. Cladding of either side of an insulated block joint greatly improves its lipping resistance and allows it to withstand approximately 3 times the energy input into the contact compared to a standard un-clad IBJ. A section of rail clad with martensitic stainless steel was subject to bend fatigue testing and ran out to 5,000,000 cycles at a stress range of 350 MPa matching the performance of an unclad R260 rail. Although there is no standard for the bend testing of laser clad rail this performance exceeds the performance requirements of the NR/SP/TRK111 standard which governs the bend testing of flash but welded rail. (C) 2017 Elsevier B.V. All rights reserved.