Evaluation of Switching Performance of SiC Devices in PWM Inverter-Fed Induction Motor Drives

Double pulse test (DPT) is a widely accepted method to evaluate the switching characteristics of semiconductor switches, including SiC devices. However, the observed switching performance of SiC devices in a PWM inverter for induction motor drives is almost always worse than the DPT characterization, with slower switching speed, more switching losses, and more serious parasitic ringing. This paper systematically investigates the factors that limit the SiC switching performance from both the motor side and inverter side, including the load characteristics of induction motor and power cable, two more phase legs for the three-phase PWM inverter in comparison with the DPT, and the parasitic capacitive coupling effect between power devices and heat sink. Based on a three-phase PWM inverter with 1200 V SiC MOSFETs, test results showthat the induction motor, especially with a relatively long power cable, will significantly impact the switching performance, leading to a switching time increase by a factor of 2, switching loss increase up to 30% in comparison with that yielded from DPT, and serious parasitic ringing with 1.5 mu s duration, which is more than 50 times of the corresponding switching time. In addition, the interactions among the three phase legs cannot be ignored unless the decoupling capacitors are mounted close to each phase leg to support the dc bus voltage during switching transients. Also, the coupling capacitance due to the heat sink equivalently increases the junction capacitance of power devices; however, its influence on the switching behavior in the motor drives is small considering the relatively large capacitance of the motor load.