A method for the identification of the specific force coefficients for mechanistic milling simulation

This paper presents a new method to obtain the specific cutting coefficients needed to predict the milling forces using a mechanistic model of the process. The specific coefficients depend on the tool-material couple, the cutting conditions and the geometry of the tool, being usually calculated applying the force model in an inverse way. The most used inverse method is based on the calculation of the average cutting force per revolution values measured in a series of slot machining tests at different feed rates. In this research work, the inverse method is applied using the instantaneous cutting force values, solving the equations system by a constrained least squares fitting method. Furthermore, the cutting force and specific cutting coefficients relation with rake angle and chip thickness is analysed. The results are validated by the comparison of the simulations and experiments in orthogonal cutting test, showing the advantages of using the new method. (C) 2010 Elsevier Ltd. All rights reserved.