Numerical simulation and experimental study on floor failure mechanism of typical working face in thick coal seam in Chenghe mining area of Weibei, China

被引:29
|
作者
Li, Ang [1 ,2 ]
Ma, Qiang [1 ,2 ]
Lian, Yanqing [3 ,4 ]
Ma, Li [2 ]
Mu, Qian [1 ]
Chen, Jianbo [1 ]
机构
[1] Xian Univ Sci & Technol, Sch Architecture & Civil Engn, Xian 710054, Shaanxi, Peoples R China
[2] Minist Land & Resources, Key Lab Coal Resources Explorat & Comprehens Util, Xian 710021, Shaanxi, Peoples R China
[3] Chinese Acad Sci, Inst Earth Environm, Key Lab Loess & Quaternary Geol, 97 Yanxiang Rd, Xian 710061, Shaanxi, Peoples R China
[4] Univ Illinois, Prairie Res Inst, 2204 Griffith Dr, Champaign, IL 61820 USA
关键词
Chenghe mining area; No; 5 coal seam; Mining under safe water pressure of aquifer; Floor failure depth; Numerical simulation; WATER INRUSH; INDUCED FRACTURE; RISK-EVALUATION; FAULT; MINE;
D O I
10.1007/s12665-020-8839-2
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
The hydrogeological conditions of Weibei coalfield in China are complex; the main mining No. 5 coal seam is seriously threatened by Ordovician limestone karst water disaster at the bottom of coal measures. Chenghe No. 2 Mine is a typical example. With the increase of mining depth, confined water pressure increases year by year. To find out the law of floor deformation and failure caused by No. 5 coal seam mining in Chenghe No. 2 Coal Mine, this paper takes 24,508 working face of Chenghe No. 2 Coal Mine as engineering geological background, and carries out research by numerical simulation and field test methods. The stress field, displacement field distribution law and plastic zone evolution characteristics of No. 5 coal seam roof and floor varying with the advancing degree of mining face are obtained by simulation calculation. The progressive failure process of the whole floor stratum is reproduced dynamically, and the development height of the water conducting fracture zone of overburden is given. The maximum failure depth of the floor occurs at the mining distance of about 1.5 times the mining width, at which time "the saddle shape" supporting pressure arch reaches its maximum. At the same time, the multi-point separated layer displacement meter is used to carry out field measurements. The results show that the maximum failure depth of floor occurs in the goaf, and the maximum range of the relative displacement of the floor is 8.0-8.5 m, which is close to - 6.1 m from the coal mining surface, consistent with the results of the numerical simulation. Comprehensive analysis shows that the maximum failure depth of coal seam floor in Chenghe No. 2 Coal Mine is 8.3 m. The conclusion provides a favorable basis for the rational formulation of water disaster control countermeasures. It provides reference and experience for mining under safe water pressure of aquifuge for prevention and cure water of similar working face in Chenghe mining area in the future.
引用
收藏
页数:22
相关论文
共 50 条
  • [1] Numerical simulation and experimental study on floor failure mechanism of typical working face in thick coal seam in Chenghe mining area of Weibei, China
    Ang Li
    Qiang Ma
    Yanqing Lian
    Li Ma
    Qian Mu
    Jianbo Chen
    Environmental Earth Sciences, 2020, 79
  • [2] Research on a Numerical Simulation and Prediction Model of Floor Mining Failure Depth in the Chenghe Mining Area
    Li, Ang
    Mu, Qian
    Zhang, Wenzhong
    Liu, Chaoyang
    Wang, Feng
    Mou, Lin
    GEOFLUIDS, 2020, 2020
  • [3] NUMERICAL SIMULATION OF A FAILURE PATTERN OF THE ROOF IN COAL SEAM WORKING FACE
    Zhang, Xiu-Feng
    Zhang, Ning
    Li, Xiang
    Liu, Chuan-Cheng
    Chen, Yang
    THERMAL SCIENCE, 2024, 28 (2A): : 1149 - 1154
  • [4] NUMERICAL SIMULATION OF A FAILURE PATTERN OF THE ROOF IN COAL SEAM WORKING FACE
    Zhang, Xiu-Feng
    Zhang, Ning
    Li, Xiang
    Liu, Chuan-Cheng
    Chen, Yang
    THERMAL SCIENCE, 2024, 28 (02): : 1149 - 1154
  • [5] Study of Top Coal's Short Beam Layer Failure Mechanism of Sublevel Caving Mining Working Face in Extremely Thick Coal Seam
    Nan Hua
    Li Xiaojun
    Zhou Ying
    PROGRESS IN SAFETY SCIENCE AND TECHNOLOGY, VOL VII, PTS A AND B, 2008, 7 : 1621 - 1623
  • [6] Mechanism of the coal bursts in the working face during mining of steeply inclined and extra thick coal seam
    Cao, Jinrong
    Dou, Linming
    He, Jiang
    Xie, Jiahao
    Han, Zepeng
    Wang, Songwei
    GEOMATICS NATURAL HAZARDS & RISK, 2023, 14 (01)
  • [7] NUMERICAL SIMULATION ON MINING FAILURE CHARACTERISTICS OF COAL SEAM FLOOR ABOVE CONFINED AQUIFER
    Dai, Hong-Bao
    Xu, Ji-Ying
    ENERGY, ENVIRONMENTAL & SUSTAINABLE ECOSYSTEM DEVELOPMENT, 2016,
  • [8] Microseismic Monitoring and Numerical Simulation Research of Floor Failure Depth in Extra-Thick Coal Seam
    Cheng, Ai-Ping
    Gao, Yong-Tao
    Liu, Chao
    Chai, Jin-Fei
    CHEMICAL, MATERIAL AND METALLURGICAL ENGINEERING III, PTS 1-3, 2014, 881-883 : 1799 - 1804
  • [9] Study on lithologic effect of mining-induced failure mechanism of coal seam floor
    Zhang F.
    Meitan Kexue Jishu/Coal Science and Technology (Peking), 2023, 51 (11): : 166 - 178
  • [10] Effect of floor failure in fully mechanized caving of extra-thick coal seam in Datong Mining Area
    Duan H.
    Zhao L.
    Chen Y.
    Arabian Journal of Geosciences, 2021, 14 (11)