Pulsed laser deposition and characterization of InZnO alloyed thin film

High-quality In2O3 powder and ZnO powder had been used to make the ceramic target and the atomic ratio of 1 to 1 of indium and zinc had been prepared in this study. The alloyed thin films had been deposited on sapphire (001) substrates at different temperatures (100-600 degrees C) by using pulsed laser deposition (PLD) technique. An x-ray diffractometer and an atomic force microscope were used to investigate the structural and morphological properties of the alloyed thin films. It was observed that the alloyed thin films deposited at the temperatures lower than 300 degrees C were amorphous, and the alloyed thin films deposited at high temperatures were crystallized. A spectrophotometer was used to investigate the transmittances of the alloyed thin films. It was found that the alloyed thin films were of high quality. The band gap energies of the alloys were calculated by linear fitting the sharp absorption edges of the transmittance spectra. The Hall measurements were also carried out to identify the electrical properties of the thin films.