Structural health monitoring of defective single lap adhesive joints using graphene nanoplatelets

被引:27
|
作者
Sam-Daliri, Omid [1 ,2 ]
Farahani, Mohammadreza [1 ]
Faller, Lisa-Marie [3 ]
Zangl, Hubert [2 ]
机构
[1] Univ Tehran, Coll Engn, Sch Mech Engn, Tehran 1439957131, Iran
[2] Alpen Adria Univ Klagenfurt, Inst Smart Syst Technol, Sensors & Actuators Dept, A-9020 Klagenfurt, Austria
[3] Carinthia Univ Appl Sci CUAS, FH Karnten, A-9524 Villach, Austria
基金
美国国家科学基金会;
关键词
Graphene nanoplatelets; Adhesive joint; Damage sensing; Electrical impedance; MECHANICAL-PROPERTIES; STRAIN; COMPOSITES; NANOCOMPOSITE; DAMAGE;
D O I
10.1016/j.jmapro.2020.03.063
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Adhesive joints are becoming increasingly important in engineering, especially in the field of mobile applications such as automotive and aircraft. As done in recent studies, Functionalized graphene nanoplatelets (f-GNPs) additives are a good candidate for improving the mechanical strength of the adhesives. Additionally, adhesives containing f-GNPs also exhibit a piezoresistive effect, i.e. the electrical resistance changes when subjected to mechanical stress. Consequently, they are ideally suited to be used for damage sensing in fibre-reinforced composite materials, and adhesive joints. In this work, the capability of f-GNPs for structural health monitoring and reinforcement of a defective single lap Al-Al adhesive joints under shear load is studied using the electrical impedance measurement. In order to study damage progression in the adhesive layer under shear stress, several artificial defects in circular and square shapes with different sizes are inserted into the adhesive joints. The effects of defects on the damage progression in the adhesive layer are studied by a correlation between fracture surface and impedance changes. The results showed that f-GNP adhesive is sensitive to deformation and damage extension in the adhesive layer. The ultimate strength has improved about 74 % by incorporating the 12 wt.% f-GNP into the adhesive joint without embedded defect. The maximum impedance changes (Delta R/R) were obtained almost 60 % close to the failure point for defective adhesive joint comprised of a square defect shape and 50 % defect area. This phenomenon was observed when the fracture occurred from the interface between the adhesive layer and the Al substrate.
引用
收藏
页码:119 / 130
页数:12
相关论文
共 50 条
  • [1] The effect of graphene and graphene oxide on defective single lap adhesively bonded joints
    Abdi, Esmaeil
    Khabaz-Aghdam, Ata
    Hasan-nezhad, Hosein
    Behjat, Bashir
    Marques, E. A. S.
    Yang, Yongming
    da Silva, L. F. M.
    JOURNAL OF COMPOSITE MATERIALS, 2022, 56 (17) : 2665 - 2675
  • [2] Finite difference model of wave motion for structural health monitoring of single lap joints
    Carrino, Stefano
    Nicassio, Francesco
    Scarselli, Gennaro
    Vitolo, Raffaele
    INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES, 2019, 161 : 219 - 227
  • [3] SHM of single lap adhesive joints using subharmonic frequencies
    Ginzburg, D.
    Ciampa, F.
    Scarselli, G.
    Meo, M.
    SMART MATERIALS AND STRUCTURES, 2017, 26 (10)
  • [4] Structural health monitoring of adhesive joints using Lamb waves: A review
    Ramalho, Gabriel M. F.
    Lopes, Antonio M.
    da Silva, Lucas F. M.
    STRUCTURAL CONTROL & HEALTH MONITORING, 2022, 29 (01):
  • [5] Piezocapacitive Sensing for Structural Health Monitoring in Adhesive Joints
    Stetco, Christian
    Sam-Dalirit, Omid
    Faller, Lisa-Marie
    Zangl, Hubert
    2019 IEEE INTERNATIONAL INSTRUMENTATION AND MEASUREMENT TECHNOLOGY CONFERENCE (I2MTC), 2019, : 1331 - 1335
  • [6] Assessing Weak Adhesion in Single Lap Joints Using Lamb Waves and Machine Learning Methods for Structural Health Monitoring
    Ramalho, Gabriel M. F.
    Lopes, Antonio M.
    da Silva, Lucas F. M.
    APPLIED SCIENCES-BASEL, 2023, 13 (19):
  • [7] Analysis of Single Lap Adhesive Joints between Magnesium and Other Structural Automotive Materials
    Mallick, P. K.
    Bhambure, Shardul
    SAE INTERNATIONAL JOURNAL OF MATERIALS AND MANUFACTURING, 2011, 4 (01) : 175 - 180
  • [8] Effects of adhesive fillers on the strength of tubular single lap adhesive joints
    Lee, DG
    Kim, JK
    Cho, DH
    JOURNAL OF ADHESION SCIENCE AND TECHNOLOGY, 1999, 13 (11) : 1343 - 1360
  • [9] Static failure analysis of adhesive single lap joints
    da Costa Mattos, H. S.
    Sampaio, E. M.
    Monteiro, A. H.
    INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES, 2011, 31 (06) : 446 - 454
  • [10] Fatigue behavior of single lap adhesive composite joints
    Saunders, I
    Dzenis, YA
    RECENT DEVELOPMENTS IN DURABILITY ANALYSIS OF COMPOSITE SYSTEMS, 2000, : 127 - 131