Investigation on microstructure characterizations and phase compositions of rapidly solidification/powder metallurgy Mg-6 wt.% Zn-5 wt.% Ce-1.5 wt.% Ca alloy

被引：14
|
作者：
Zhou, Tao [1 ]
Xia, Hua [1 ]
Yang, Mingbo [1 ]
Zhou, Zhiming [1 ]
Chen, Kang [1 ]
Hu, Jianjun [1 ]
Chen, Zhenhua [2 ]
机构：
[1] Chongqing Univ Technol, Coll Mat Sci & Engn, Chongqing 400054, Peoples R China
[2] Hunan Univ, Coll Mat Sci & Engn, Changsha 410082, Hunan, Peoples R China
来源：
JOURNAL OF ALLOYS AND COMPOUNDS | 2011年 / 509卷 / 09期
关键词：
Rapidly solidification/powder metallurgy; Mg-Zn-Ce-Ca alloy; Microstructure; Thermal property; UNDERCOOLED NICKEL-TIN; RARE-EARTH ALLOYS; MECHANICAL-PROPERTIES; DENDRITIC GROWTH; MAGNESIUM ALLOYS; Y ALLOYS; SYSTEM; BEHAVIOR;
D O I：
10.1016/j.jallcom.2010.12.133
中图分类号：
O64 [物理化学（理论化学）、化学物理学];
学科分类号：
070304 ; 081704 ;
摘要：
Rapidly solidification/powder metallurgy (RS/PM) Mg-6Zn-5Ce-1.5Ca (wt.%) alloy in form of rods has been prepared by hot extrusion with RS powders, produced via atomizing the alloy melt and subsequent splat-quenching on the water-cooled copper twin-rollers. Microstructure characterizations and phase compositions of the alloy have been investigated. The results showed that the RS/PM Mg-6Zn-5Ce-1.5Ca alloy was the characteristics of very fine grains with the size ranging from 200 to 650 nm and was composed of alpha-Mg, Mg(x)Zn(y)Ce(z) phase with a few Ca (about 1 at.%) shortened as the Mg(x)Zn(y)Ce(z)-(Ca) phase, and a small quantity of Mg(51)Zn(20) phases. The melting point of the Mg(x)Zn(y)Ce(z)-(Ca) phase in the alloy was a little higher than that of the Mg(x)Zn(y)Ce(z) phase in RS/PM Mg-6Zn-5Ce alloy, which may be due to the dissolving of Ca in it. Moreover, the atomic percentage ratio of Zn to Ce in the Mg(x)Zn(y)Ce(z)-(Ca) phase around the grain boundary was close to 1.5. (C) 2010 Elsevier B.V. All rights reserved.
引用
收藏
页码：L145 / L149
页数：5
相关论文
共 50 条
  • [1] Investigation on microstructures and properties of rapidly solidified Mg-6 wt.% Zn-5 wt.% Ca-3 wt.% Ce alloy
    Zhou, T.
    Chen, D.
    Chen, Z.H.
    Chen, J.H.
    Journal of Alloys and Compounds, 2009, 475 (1-2):
  • [2] Investigation on microstructures and properties of rapidly solidified Mg-6 wt.% Zn-5 wt.% Ca-3 wt.% Ce alloy
    Zhou, T.
    Chen, D.
    Chen, Z. H.
    Chen, J. H.
    JOURNAL OF ALLOYS AND COMPOUNDS, 2009, 475 (1-2) : L1 - L4
  • [3] Investigation on microstructures and properties of rapidly solidified Mg-6 wt. %Zn-5 wt. % Ca-3 wt. % Ce alloy (vol 475, pg L1, 2009)
    Zhou, T.
    Chen, D.
    Chen, Z. H.
    Chen, J. H.
    JOURNAL OF ALLOYS AND COMPOUNDS, 2024, 970
  • [4] Investigation on the microstructural refinement of an Mg-6 wt.% Zn alloy
    Das, A
    Liu, G
    Fan, Z
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2006, 419 (1-2): : 349 - 356
  • [5] Strain-rate dependence of microstructure and superplasticity of an Al-16 wt.% Si-5 wt.% Fe-0.9 wt.% Cu-0.4 wt.% Mg-0.9 wt.% Zr alloy fabricated by powder metallurgy
    Jeong, HG
    Hiraga, K
    Cho, HS
    Kim, MS
    MATERIALS LETTERS, 2000, 45 (02) : 86 - 90
  • [6] Microstructure and Electrochemical Performance Evaluation of Zn, Zn-5 wt.% Al and Zn-20 wt.% Al Alloy Coated Steels
    Manna, M.
    Dutta, M.
    Bhagat, A. N.
    JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2021, 30 (01) : 627 - 637
  • [7] Microstructure and Electrochemical Performance Evaluation of Zn, Zn-5 wt.% Al and Zn-20 wt.% Al Alloy Coated Steels
    M. Manna
    M. Dutta
    A. N. Bhagat
    Journal of Materials Engineering and Performance, 2021, 30 : 627 - 637
  • [8] Solidification, solution treatment and age hardening of a Mg-1.6 wt.% Ca-3.2 wt.% Zn alloy
    Levi, G
    Avraham, S
    Zilberov, A
    Bamberger, M
    ACTA MATERIALIA, 2006, 54 (02) : 523 - 530
  • [9] Microstructure and Hot Deformation Behavior of the Mg-8 wt.% Sn-1.5 wt.% Al Alloy
    Sun, Zhaoqian
    Li, Yongjun
    Zhang, Kui
    Li, Xinggang
    Ma, Minglong
    Shi, Guoliang
    Yuan, Jiawei
    Zhang, Hongju
    MATERIALS, 2021, 14 (08)
  • [10] The effects of yttrium element on microstructure and mechanical properties of Mg-5 wt.% Zn-2 wt.% Al alloy
    Zou, HH
    Zeng, XQ
    Zhai, CQ
    Ding, WJ
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2005, 402 (1-2): : 142 - 148
12345