Impacts of CO2 emission constraints on technology selection and energy resources for power generation in Bangladesh

被引:25
|
作者
Mondal, Md Alam Hossain [1 ,2 ]
Mathur, Jyotirmay [3 ]
Denich, Manfred [1 ]
机构
[1] Univ Bonn, Ctr Dev Res ZEF, D-53113 Bonn, Germany
[2] Bangladesh Atom Energy Commiss, Atom Energy Res Estab, Energy Inst, Dhaka, Bangladesh
[3] Malaviya Natl Inst Technol, Dept Mech Engn, Jaipur 302017, Rajasthan, India
关键词
MARKAL; CO2 emission reduction and carbon tax; Power sector; SECTOR; REDUCTION; VIETNAM;
D O I
10.1016/j.enpol.2011.01.044
中图分类号
F [经济];
学科分类号
02 ;
摘要
This paper examines the impacts of CO2 emission reduction target and carbon tax on future technologies selection and energy use in Bangladesh power sector during 2005-2035. The analyses are based on a long-term energy system model of Bangladesh using the MARKAL framework. The analysis shows that Bangladesh will not be able to meet the future energy demand without importing energy. However, alternative policies on CO2 emission constraints reduce the burden of imported fuel, improve energy security and reduce environmental impacts. The results show that the introduction of the CO2 emission reduction targets and carbon taxes directly affect the shift of technologies from high carbon content fossil-based to low carbon content fossil-based and clean renewable energy-based technologies compared to the base scenario. With the cumulative CO2 emission reduction target of 10-20% and carbon tax of 2500 Taka/ton, the cumulative net energy imports during 2005-2035 would be reduced in the range of 39-65% and 37%, respectively, compared to the base scenario emission level. The total primary energy requirement would be reduced in the range of 4.5-22.3% in the CO2 emission reduction targets and carbon tax 2500 Taka/ton scenarios and the primary energy supply system would be diversified compared to the base scenario. (C) 2011 Elsevier Ltd. All rights reserved.
引用
收藏
页码:2043 / 2050
页数:8
相关论文
共 50 条
  • [1] Impacts of CO2 emission constraints on penetration of solar PV in the Bangladesh power sector
    Mondal, Md Alam Hossain
    Islam, A. K. M. Sadrul
    RENEWABLE ENERGY, 2012, 43 : 418 - 422
  • [2] CO2 emission coupled power generation mix evolution with flexible energy resources
    Li, Lingtao
    Xiang, Yue
    Guo, Yongtao
    Zeng, Pingliang
    Xu, Weiting
    Liu, Youbo
    Liu, Junyong
    IET SMART GRID, 2024, 7 (02) : 142 - 156
  • [3] Impacts of wind power generation and CO2 emission constraints on the future choice of fuels and technologies in the power sector of Vietnam
    Nguyen, Khanh Q.
    ENERGY POLICY, 2007, 35 (04) : 2305 - 2312
  • [4] Reliable role of nuclear power generation under CO2 emission constraints
    Lee, Young-Eal
    Jung, Young-Beom
    NUCLEAR ENGINEERING AND TECHNOLOGY, 2007, 39 (05) : 655 - 662
  • [5] State of energy consumption and CO2 emission in Bangladesh
    Azad, AK
    Nashreen, SW
    Sultana, J
    AMBIO, 2006, 35 (02) : 86 - 88
  • [6] State of Energy Consumption and CO2 Emission in Bangladesh
    Abul K.Azad
    yahoo.com
    S.W.Nashreen
    J.Sultana
    AMBIO-人类环境杂志, 2006, 35 (02) : 86 - 88
  • [7] Mitigation of CO2 Emission in Conventional Power Generation with Renewable energy
    Zaheeruddin
    Kumar, Raj
    Kumar, Atul
    Jain, V. K.
    2015 1ST INTERNATIONAL CONFERENCE ON FUTURISTIC TRENDS ON COMPUTATIONAL ANALYSIS AND KNOWLEDGE MANAGEMENT (ABLAZE), 2015, : 734 - 738
  • [8] Impacts of CO2 constraints on energy systems in Japan
    Nakata, T
    Lamont, A
    Watz, J
    TECHNOLOGY'S CRITICAL ROLE IN ENERGY & ENVIRONMENTAL MARKETS, CONFERENCE PROCEEDINGS, 1998, : 386 - 395
  • [9] Technology options for gas turbine power generation with reduced CO2 emission
    Griffin, Timothy
    Buecker, Dominikus
    Pfeffer, Allen
    Proceedings of the ASME Turbo Expo 2005, Vol 5, 2005, : 473 - 481
  • [10] Technology options for gas turbine power generation with reduced CO2 emission
    Griffin, Timothy
    Buecker, Dominikus
    Pfeffer, Allen
    JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2008, 130 (04):