Influence of Increased Voltage on the Characteristics of Printed Circuit Board Protective Coatings

被引：0

作者：

Hirman, Martin ^{[1
]}

Steiner, Frantisek ^{[1
]}

Hornak, Jaroslav ^{[1
]}

Pihera, Josef ^{[1
]}

Rous, Pavel ^{[2
]}

机构：

[1] Univ West Bohemia, Fac Elect Engn, Dept Technol & Measurements RICE, Plzen, Czech Republic

[2] Univ West Bohemia, Fac Elect Engn, Dept Technol & Measurements, Plzen, Czech Republic

来源：

2018 INTERNATIONAL CONFERENCE ON DIAGNOSTICS IN ELECTRICAL ENGINEERING (DIAGNOSTIKA) | 2018年

关键词：

Conformal coating; increased voltage ageing; surface insulation resistance;

D O I：

暂无

中图分类号：

TM [电工技术]; TN [电子技术、通信技术];

学科分类号：

0808 ; 0809 ;

摘要：

The article presents a research focused on printed circuit board protective coatings as an option for the assembled PCBs cover and electronic device reliability improvement. The experiment with different coatings is described in this article. For the experiment, rigid substrate (FR-4) is used. The protective coatings from acrylic, urethane, silicone and fluoropolymer materials were used. The differences in substrates and coatings have an effect on the insulation resistance which was measured by SIR test. The samples were exposed to accelerated aging test by increased voltage. The advantages, disadvantages, comparison and results from measurement are discussed in this paper. The results present the comparison of the tested conformal coatings. The importance of cleaning before application of coatings is the next part of results.

引用

页数：6

共 50 条

[1] The Influence of Corrosion Test on Performances of Printed Circuit Board Coatings
Ju, Chengyu
Wang, Xiaohui
Zhu, Run
Ren, Xiaoming
ENGINEERING ASSET MANAGEMENT - SYSTEMS, PROFESSIONAL PRACTICES AND CERTIFICATION, 2015, : 1349 - 1357
[2] Degradation of printed circuit board coatings due to partial discharge
Emersic, Christopher
Zhang, Chao
Cotton, Ian
Lowndes, Robert
Rowland, Simon
Freer, Robert
2015 IEEE ELECTRICAL INSULATION CONFERENCE (EIC), 2015, : 420 - 423
[3] INFRARED AND ULTRAVIOLET CURING OF PRINTED CIRCUIT BOARD COATINGS.
Pray, Robert W.
Insulation/Circuits, 1975, 21 (10): : 45 - 46
[4] Study on Insulation Breakdown Characteristics of Printed Circuit Board under Continuous Square Impulse Voltage
Zhou, Quan
Wen, Mingqian
Xiong, Taotao
Jiang, Tianyan
Zhou, Ming
Ouyang, Xi
Xing, Lai
ENERGIES, 2018, 11 (11)
[5] Feasibility study of the application of voltage contrast to printed circuit board
Tan, CM
Gan, ZH
Chai, TC
MICROELECTRONICS RELIABILITY, 2006, 46 (5-6) : 939 - 948
[6] Influence of printed circuit board thickness in wave soldering
Aziz, M. S. Abdul
Abdullah, M. Z.
Khor, C. Y.
Azid, I. A.
Jalar, A.
Ani, F. Che
SCIENTIA IRANICA, 2017, 24 (06) : 2963 - 2976
[7] Printed Circuit Board
China's Foreign Trade, 1998, (01) : 14 - 14
[8] The Accelerated Degradation Test and Evaluation Methods for Printed Circuit Board Coatings
Zhu, Run
Wang, Xiaohui
Ren, Xiaoming
PROCEEDINGS OF 2014 PROGNOSTICS AND SYSTEM HEALTH MANAGEMENT CONFERENCE (PHM-2014 HUNAN), 2014, : 474 - 477
[9] Modeling a Broadband Amplifier on a Printed Circuit Board with an Increased Conductivity Dielectric
Abrameshin D.A.
Pozhidaev E.D.
Saenko V.S.
Tumkovskiy S.R.
Russ. Microelectr., 2023, 7 (659-664): : 659 - 664
[10] Characteristics of environmental factor for electrochemical migration on printed circuit board
Noh, Bo-In
Jung, Seung-Boo
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS, 2008, 19 (10) : 952 - 956

← 1 2 3 4 5 →