Evaluation of different stenting techniques in coronary bifurcations

The objective of this work is to analyze the local hemodynamic changes caused in a coronary bifurcation by three different stenting techniques: simple stenting of the main vessel, simple stenting of the main vessel with kissing balloon in the side branch and culotte. To carry out this study an idealized geometry of a coronary bifurcation is used, and two bifurcation angles, 45 degrees and 90 degrees, are chosen as representative of the wide variety of real configurations. Both numerical simulations and experimental measurements are performed. First, steady simulations are carried out with the commercial code ANSYS Fluent, then, experimental measurements with PIV (Particle Image Velocimetry), obtained in the laboratory, are used to validate the numerical simulations. The steady computational simulations show a good overall agreement with the experimental data. Second, pulsatile flow is considered to take into account the transient effects. The time averaged wall shear stress, oscillatory shear index ( OSI) and pressure drop obtained numerically are used to compare the behavior of the stenting techniques. As conclusions obtained, simple stenting technique shows the worst results in terms of pressure drop, and kissing the best ones. This criterion could be applied for DES (Drug Eluting Stents) where the restenosis is not as critical as the reestablishment of the blood flow. But considering the regions of low wall shear stress (<0.4 Pa) and elevated OSI (> 0.1), the culotte procedure shows the worst performance and the simple stent, the best. This could be applied to BMS (Bare Metal Stents). (C) 2015 CIMNE (Universitat Politecnica de Catalunya). Published by Elsevier Espana, S.L.U.