Effect of geometrical parameters on the performance of chevron type plate heat exchanger'

This work reports the effects of geometrical parameters on the hydraulic and thermal performance of a single pass U-type plate heat exchanger for the range of Reynolds number 800-2300. Influence of chevron angle on mean channel friction factor, mean channel pressure drop, and effectiveness is experimentally investigated. The current investigation also presents the in-depth analysis of flow non-uniformity or maldistribution on the performance of plate heat exchangers Two symmetrical plates set with chevron angle, beta = 60 degrees/60 degrees and 30 degrees/30 degrees, and one unsymmetrical plate set with chevron angle beta = 60 degrees/30 degrees are used. The experiments are conducted for 21 channels (11 cold fluid and 10 hot fluid) plates set using water as the fluid. Chevron angle significantly affects the fluid flow distribution in the channels which eventually has a severe impact on the thermal performance and power consumption of a PHE. The increase in mean channel pressure drop on increasing chevron angle from (30 degrees/30 degrees) to (60 degrees/30 degrees) and (60 degrees/30 degrees) to (60 degrees/60 degrees) is found to be 22.05% and 37.9% respectively. For the same increments of chevron angle, enhancement in effectiveness is found to be 17.73% and 22.05% respectively. Effectiveness is also found to be monotonically decreasing with increase in mass flow rate for all the chevron angles. Based on the experimental data, empirical correlations for the friction factor and effectiveness, taking into consideration chevron angle and enlargement factor, are developed.