Improvement of heat transfer with perforated circular holes in finned tubes of air-cooled heat exchanger

被引：42

作者：

Lee, Dong H. ^{[2
]}

Jung, Jin M. ^{[1
]}

Ha, Jong H. ^{[3
]}

Cho, Young I. ^{[1
]}

机构：

[1] Drexel Univ, Dept Mech Engn & Mech, Philadelphia, PA 19104 USA

[2] Chonbuk Natl Univ, Coll Engn, Dept Mech Design Engn, Jeonju, Jeonbuk, South Korea

[3] Korea Heat Exchanger Co Ltd, Gunsan, Jeonbuk, South Korea

来源：

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER | 2012年 / 39卷 / 02期

关键词：

Heat exchanger; Finned tube; Perforation; Circular fin; SIDE PERFORMANCE; FLOW; TURBULENT; WINGLETS; PIPE;

D O I：

10.1016/j.icheatmasstransfer.2011.11.009

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

The present study investigated the effect of perforated circular finned-tube (PCFT) on the convective heat transfer performance of circular finned-tube heat exchangers. The air-side convective heat transfer coefficients increased by 3.55% and 3.31% for 2-hole and 4-hole PCFT cases, respectively. The increase in the convective heat transfer coefficient was related to the reduction of the recirculation region by introducing the perforations at the flow-separation locations on the finned tube. The pressure drop across the finned-tube bundles increased by 0.68% and 2.08% for the 2-hole PCFT and 4-hole PCFT cases, respectively. The greater pressure drop in the case of the 4-hole PCFT might be due to excessive flow disturbances produced by multiple perforations. The fin factor defined as the ratio of the % increase of the convective heat transfer coefficient and that of the pressure drop was 5.19 for the 2-hole PCFT case, whereas that was 1.59 for the 4-hole PCFT case. (C) 2011 Elsevier Ltd. All rights reserved.

引用

下载

页码：161 / 166

页数：6

共 50 条

[1] FINNED ELLIPTICAL TUBES AND THEIR APPLICATION IN AIR-COOLED HEAT EXCHANGERS
SCHULENB.FJ
MECHANICAL ENGINEERING, 1965, 87 (11) : 80 - &
[2] FINNED ELLIPTICAL TUBES AND THEIR APPLICATION IN AIR-COOLED HEAT EXCHANGERS
SCHULENBERG, FJ
JOURNAL OF ENGINEERING FOR INDUSTRY, 1966, 88 (02): : 179 - +
[3] Constructal design of finned tubes used in air-cooled heat exchangers
Hossein Shokouhmand
Shoeib Mahjoub
Mohammad Reza Salimpour
Journal of Mechanical Science and Technology, 2014, 28 : 2385 - 2391
[4] NEW DESIGNS OF BIMETALLIC FINNED TUBES FOR AIR-COOLED HEAT EXCHANGERS
Kuntysh, V. B.
Sankovich, E. S.
Sukhotsky, A. B.
Mulin, V. P.
CHEMICAL AND PETROLEUM ENGINEERING, 2013, 49 (1-2) : 65 - 72
[5] Constructal design of finned tubes used in air-cooled heat exchangers
Shokouhmand, Hossein
Mahjoub, Shoeib
Salimpour, Mohammad Reza
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY, 2014, 28 (06) : 2385 - 2391
[6] Experimental research on heat transfer performance for finned-tubes of direct air-cooled condensers
Yang, J. (yjglryz@sina.com), 2012, Chinese Society for Electrical Engineering (32):
[7] Experimental and Numerical Investigation of the Air Side Heat Transfer of a Finned Tubes Heat Exchanger
Petrik, Mate
Szepesi, Gabor
PROCESSES, 2020, 8 (07)
[8] Cooling enhancement in an air-cooled finned heat exchanger by thin water film evaporation
Song, CH
Lee, DY
Ro, ST
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2003, 46 (07) : 1241 - 1249
[9] Numerical simulation on flow and heat transfer of fin structure in air-cooled heat exchanger
Li, Li
Du, Xiaoze
Yang, Lijun
Xu, Yan
Yang, Yongping
APPLIED THERMAL ENGINEERING, 2013, 59 (1-2) : 77 - 86
[10] Advances in air-cooled heat exchanger technology
Webb, Ralph L.
Kim, N.-H.
JOURNAL OF ENHANCED HEAT TRANSFER, 2007, 14 (01) : 1 - 26

← 1 2 3 4 5 →