Mitigation of Bearing Current and Shaft Voltage Using Five Level Inverter in Three Phase Induction Motor Drive with SPWM Technique

被引:0
|
作者
Dhatrak, Rajendra K. [1 ]
Dash, Soubhagya Kumar [1 ]
Nema, Rajesh K. [1 ]
Deshpande, Dinesh M. [2 ]
机构
[1] MANIT, Dept Elect Engn, Bhopal, Madhya Pradesh, India
[2] SIRTS, Dept Elect & Elect Engn, Bhopal, Madhya Pradesh, India
关键词
Bearing current; bearing voltage; common mode voltage (CMV); total harmonic distortion (THD); COMMON-MODE VOLTAGE; MULTILEVEL INVERTERS; ELIMINATION; CONVERTERS;
D O I
暂无
中图分类号
TP [自动化技术、计算机技术];
学科分类号
0812 ;
摘要
Induction motor can be run as variable speed a.c. drive under the umbrella of recent technology advancements. Pulse width modulated (PWM) inverters are used to feed drive efficiently. Problems observed due to conventional inverter like: common mode voltage (CMV), total harmonic distortion (THD) in line voltage waveform, electromagnetic interference, inverter induced bearing current and shaft voltage owing to high rate of rise of voltage and more carrier frequency. These barriers are reduced using multilevel inverters. This paper proposed to minimize these shortcomings using a five level diode clamped sinusoidal pulse width modulation (SPWM) inverter. A model is simulated using MATLAB simulink for conventional and five level inverter fed induction motor using phase disposition (PO), phase opposite disposition (POD) and alternate phase opposite disposition (APOD) techniques.
引用
下载
收藏
页码:1184 / 1189
页数:6
相关论文
共 50 条
  • [1] EXPERIMENTAL INVESTIGATION AND MEASUREMENT OF SHAFT VOLTAGE AND BEARING CURRENT IN 5-LEVEL INVERTER FED INDUCTION MOTOR DRIVE USING MICROCONTROLLER
    Muralidhara, B.
    Ramachandran, A.
    Srinivasan, R.
    Reddy, M. Channa
    FOURTH INTERNATIONAL CONFERENCE ON COMPUTER AND ELECTRICAL ENGINEERING (ICCEE 2011), 2011, : 1 - +
  • [3] Simulation and Experimental Measurement of Shaft Voltage, Bearing Current in Induction Motor Drive
    Chandrashekar, S. M.
    Ramachandran, A.
    Reddy, M. Channa
    2017 IEEE INTERNATIONAL CONFERENCE ON POWER, CONTROL, SIGNALS AND INSTRUMENTATION ENGINEERING (ICPCSI), 2017, : 732 - 737
  • [4] Common-Mode Voltage and Vibration Mitigation of a Five-Phase Three-Level NPC Inverter-Fed Induction Motor Drive System
    Payami, Saifullah
    Behera, Ranjan Kumar
    Iqbal, Atif
    Al-Ammari, Rashid
    IEEE JOURNAL OF EMERGING AND SELECTED TOPICS IN POWER ELECTRONICS, 2015, 3 (02) : 349 - 361
  • [5] Design of Five Phase Voltage Source Inverter with Time Modulated Switching Technique for Induction Motor Drive
    Raja, D.
    Ravi, G.
    2019 8TH IEEE INTERNATIONAL CONFERENCE ON COMPUTATION OF POWER, ENERGY, INFORMATION AND COMMUNICATION (ICCPEIC'19), 2019, : 215 - 220
  • [6] Comparison Power Quality of the Voltage Source Inverter type SVPWM and SPWM Technique for Induction motor Drive
    Tunyasrirut, Satean
    Srilad, Sompong
    Suksri, Tianchai
    2008 PROCEEDINGS OF SICE ANNUAL CONFERENCE, VOLS 1-7, 2008, : 230 - +
  • [7] A Novel Five-Level SPWM Inverter System for Dual-Fed Induction Motor Drive
    Rao, G. Sambasiva
    Sekhar, K. Chandra
    2012 IEEE INTERNATIONAL CONFERENCE ON ADVANCED COMMUNICATION CONTROL AND COMPUTING TECHNOLOGIES (ICACCCT), 2012, : 375 - 379
  • [8] Simulation and Analysis of Common Mode Voltage, Bearing Voltage and Bearing Current in Two-Level and Three-Level PWM Inverter Fed Induction Motor Drive with Long Cable
    Reddy, Sharana
    Basavaraja, B.
    PROCEEDINGS OF THE 2015 INTERNATIONAL CONFERENCE ON POWER AND ADVANCED CONTROL ENGINEERING (ICPACE), 2015, : 221 - 226
  • [9] Fault Mitigation in Five-Level Inverter-Fed Induction Motor Drive Using Redundant Cell
    Kiran, B. Madhu
    Ram, B. V. Sanker
    PROCEEDINGS OF THE 5TH INTERNATIONAL CONFERENCE ON FRONTIERS IN INTELLIGENT COMPUTING: THEORY AND APPLICATIONS, FICTA 2016, VOL 1, 2017, 515 : 291 - 301
  • [10] Carrier Phase Shifted SPWM for CMV reduction In a three-level inverter using Open-end winding induction motor drive
    Kumar, Narendra G.
    Srinivas, S.
    PROCEEDINGS OF THE 2016 IEEE REGION 10 CONFERENCE (TENCON), 2016, : 707 - 712